Ordering number : ENA1996 LV8417CS Bi-CMOS IC Forward/Reverse Motor Driver LV8417CS Allowable Operating Conditions at Ta = 25C, SGND = PGND = 0V Parameter Symbol Conditions Ratings Unit Power supply voltage (V pin) V 2.0 to 10.5 V M M Power supply voltage (V pin) V 2.7 to 5.5 V CC CC Input signal voltage V 0 to V V IN CC Input signal frequency f max Duty = 50% 200 kHz Electrical Characteristics Ta = 25C, V = 3.0V, V = 6.0V, SGND = PGND = 0V CC M Ratings Parameter Symbol Conditions Remarks Unit min typ max Standby load current drain IMO ENA = 0V 1 1.0 A Operating load current drain IM1 ENA = 3.0V, No load 3 80 120 A Standby control current drain ICO ENA = IN1 = IN2 = 0V 2 1.0 A Operating current consumption 1 IC1 ENA = 3.0V, No load 3 0.5 0.8 mA High-level input voltage V 2.7 V 5.5V 0.6V V V IH CC CC CC Low-level input voltage V 2.7 V 5.5V 0 0.2V V IL CC CC High-level input current I1 V = 3V 20 30 A IH IN (ENA,IN1, IN2) Low-level input current I1 V = 0V -1.0 A IL IN (ENA,IN1, IN2) Pull-down resistance value R ENA, IN1, IN2 4 100 200 400 k DN Output ON resistance R Sum of top and bottom sides ON resistance. 5 0.27 0.4 ON Low-voltage detection operating VCS1 V pin voltage 6 2.1 2.3 2.5 V CC voltage Low-voltage detection release VCS2 V pin voltage 6 2.3 2.5 2.7 V CC voltage Thermal shutdown temperature Tth Design guarantee * 7 150 180 210 C Output Turn-on time TPLH No load 8 0.10 0.15 s block Output response TIOH No load, Design guarantee * 9 0.23 0.35 s time H Turn-off time TPHL No load 8 0.10 0.15 s Output response TIOL No load, Design guarantee * 9 0.25 0.38 s time L Remarks 1. Current consumption when output at the VM pin is off. 2. Current consumption at the V pin when in all function stop. CC 3. Current consumption at the V pin when ENA=3V(IC starting time). CC 4. ENA, IN1 and IN2 pin have an internal pull-down resistor. 5. The saturation voltage of the bottom above an OUT pin is added, and the value broken by the current value is shown. 6. All output transistors are turned off if a low-voltage is detected for V . CC 7. All output transistors are turned off if the thermal protection circuit is activated. They are turned on again as the temperature goes down. 8. Rising time from 10 to 90% and falling time from 90 to 10% are specified. 9. Time until it changes OUT pin voltage 10% from the time of change of input pin voltage being 50% of V is CC specified. 50% 50% IN 90% 90% OUT 10% 10% TPLH TIOL TPHL TIOH No.A1996-2/5