MC74HC74A Dual D Flip-Flop with Set and Reset HighPerformance SiliconGate CMOS The MC74HC74A is identical in pinout to the LS74. The device MC74HC74A FUNCTION TABLE Inputs Outputs Set Reset Clock Data Q Q LH X X HL HL X X LH L L X X H* H* HH H H L HH L L H H H L X No Change H H H X No Change H H X No Change *Both outputs will remain high as long as Set and Reset are low, but the output states are unpredictable if Set and Reset go high simultaneously. MAXIMUM RATINGS Symbol Parameter Value Unit This device contains protection circuitry to guard against damage V DC Supply Voltage (Referenced to GND) 0.5 to + 7.0 V CC due to high static voltages or electric V DC Input Voltage (Referenced to GND) 0.5 to V + 0.5 V in CC fields. However, precautions must V DC Output Voltage (Referenced to GND) 0.5 to V + 0.5 V out CC be taken to avoid applications of any I DC Input Current, per Pin 20 mA voltage higher than maximum rated in voltages to this highimpedance cir- I DC Output Current, per Pin 25 mA out cuit. For proper operation, V and in I DC Supply Current, V and GND Pins 50 mA CC CC V should be constrained to the out P Power Dissipation in Still Air, SOIC Package 500 mW D range GND (V or V ) V . in out CC TSSOP Package 450 Unused inputs must always be tied to an appropriate logic voltage T Storage Temperature 65 to +150 C stg level (e.g., either GND or V ). CC T C Lead Temperature, 1 mm from Case for 10 Seconds L Unused outputs must be left open. (SOIC or TSSOP Package) 260 300 Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected. Derating: SOIC Package: 7 mW/ C from 65 to 125 C TSSOP Package: 6.1 mW/ C from 65 to 125 C RECOMMENDED OPERATING CONDITIONS Symbol Parameter Min Max Unit V DC Supply Voltage (Referenced to GND) 2.0 6.0 V CC V , V DC Input Voltage, Output Voltage (Referenced to GND) 0 V V in out CC T Operating Temperature, All Package Types 55 +125 C A t , t Input Rise and Fall Time V = 2.0 V 0 1000 ns r f CC (Figures 1, 2, 3) V = 3.0 V 0 600 CC V = 4.5 V 0 500 CC V = 6.0 V 0 400 CC Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond the Recommended Operating Ranges limits may affect device reliability.