RSL10-COIN-GEVB ON Semiconductor

EVBUM2671/D RSL10-COIN-GEVB Programming Overview RSL10COINGEVB is a Bluetooth beacon board featuring www.onsemi.com RSL10, the industrys lowest power Bluetooth 5 SoC, and N34TS108, a lowenergy temperature sensor. This board is battery powered and EVAL BOARD USERS MANUAL advertises temperature, UID and URL as beacon packets. Furthermore, RSL10COINGEVB supports Firmware overtheair (FOTA) and is CMSISPack compliant. Required Hardware & Equipment Table 1. HARDWARE DETAILS RSL10COINGEVB Chip Variant RSL10 6x6 QFN NCH RSL10101Q48ABG Antenna Type PCB Antenna Debugging Options 6pin needle connector 1pin from Interface header (UART TX) No reset button Figure 1. Top View User Input Battery holder button 2 IO Header 3 V, GND, I C, 1xGPIO External Wakeup Sources Batt. holder button (for down to 25nA operation) N34TS108 /ALERT signal GIO SPARE Temperature Sensor N34TS108 Board Supply Range 1.43.6 V Software The RSL10COINGEVB software is based on BIDK and CMSIS pack which allow for rapid development of various use cases. In order to set up the package refer to the Prerequisites section of the Bluetooth Low Energy IoT Development Kit (BIDK) Getting Started Guide Figure 2. Bottom View EVBUM2671/D Eddystone Beacon Application All of these parameters are customizable per slot. Initial firmware application for the board with basic By default the application will come with 3 slots, one for Eddystone Beacon functionality. URL, UID and TLM, that will be configurable using CMSIS Features: Configuration Wizard. Slots can be easily customized FOTA enabled directly in code to fit any other scenarios like advertising multiple URL beacons. Nonconnectable advertising mode with up to 3 Custom Device Name packet format will be also available Eddystone Beacon slots to transmit userfriendly device name. Poweroff mode with minimal power consumption Dependencies: FOTA library Bootloader Figure 4. Example Beacon Slot Configuration with 4 Active Slots Transmitting UID, URL, TLM and Device Name Frames Figure 3. Eddystone Beacon Temperature measurements will be carried out only if Application Power Modes Eddystone TLM frames are enabled. To reduce power consumption the temperature will be updated at separate Default operation mode of the board is to act as an lowduty sampling rate which will be higher that BLE Eddystone Beacon with nonconnectable advertising. advertising interval. Temperature sampling rate will be Based on compile time configuration the board will be able configurable from 1 up to 60 minutes. Temperature will be to transmit any combination of the following Eddystone measured during first advertising interval after sample frames: interval expires. Optionally highduty temperature Eddystone URL Contains encoded URL that points to measurement option can be provided to measure on every a single web page. Default URL will be pointing to TLM advertising event.