MP120D4 Opto 22

MP Series SIP SSR Ratings to 4A 280 VAC or 3A 60 VDC Triac (AC) or Transistor (DC) output DC Control Normally open (AC or DC) or normally closed output (DC only) CE Compliant to EN60950-1 PRODUCT SELECTION Control Voltage 3A 3A 4A 3A 3-32 VDC MP120D3 MP240D3 MP240D4 MPDCD3 AVAILABLE OPTIONS AC OUTPUT SPECIFICATIONS (1) Description MP120D3 MP240D3 MP240D4 Operating Voltage (47-63Hz) Vrms 12-140 24-280 24-280 Transient Overvoltage Vpk 400 600 600 Maximum Off-State Leakage Current Rated Voltage mArms 5 5 5 Minimum Off-State dv/dt Maximum Rated Voltage V/sec (2) 200 200 200 Maximum Load Current Arms 3 3 4 Minimum Load Current Arms 0.02 0.02 0.02 Maximum Surge Current (16.6ms) Apk 90 90 130 Maximum On-State Voltage Drop Rated Current Vpk 1.6 1.6 1.6 Maximum It for fusing (8.3 msec) A sec 36 36 72 Minimum Power Factor (with Maximum Load) 0.5 0.5 0.5 DC OUTPUT SPECIFICATIONS (1) Description MPDCD3 Operating Voltage Range VDC 3-60 Maximum Load Current Arms 3 Minimum Load Current Arms 0.02 Maximum Surge Current for 1 second Adc 5 Maximum On-State Voltage Drop Rated Current Vpk 1.5 Maximum Off-State Leakage Current Rated Voltage mA 1.0INPUT SPECIFICATIONS (1) Description AC Output DC Output DC Output (-B) Control Voltage Range 3-32 VDC 3-32 VDC 3-32 VDC Must Turn On Voltage 3.0 VDC 3.0 VDC 1.0 VDC Must Turn Off Voltage 1.0 VDC 1.0 VDC 3.0 VDC Typical Input Current 32VDC 23 mA 23 mA 23 mA Nominal Input Impedance 1500 Ohm 1500 Ohm 1500 Ohm Maximum Turn-On Time msec 1/2 Cycle 100 s 100 s Maximum Turn-Off Time msec 1/2 Cycle 100 s 100 s GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output(50/60Hz) 4000 Vrms 9 Minimum Insulation Resistance ( 500 VDC) 10 Ohm Maximum Capacitance, Input/Output 8 pF Ambient Operating Temperature Range -40 to 80C Ambient Storage Temperature Range -40 to 125C Weight (typical) 0.7 oz. (20g) Encapsulation Thermally Conductive Epoxy GENERAL NOTES 1) All parameters at 25C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443,13.11.1 3) Inductive loads should be diode suppressed MECHANICAL SPECIFICATIONS