Power Module Controlled Power Supply (ST-70) Operation The ST 70 requires the use of a Power Module. The Power Module selects the desired performance level for operation. The ST 70 comes standard with three Power Modules, Performance Levels 6.5, 7, & 7.5. Additional Power Modules are available in heat levels of 5, 5.5, 6, 8, and 8.5. A heat level of 5 corresponds to a nominal temperature of 500 F a heat level of 6.5 corresponds to a temperature of 650 F, etc. Actual measured temperatures on the surface of the tip may vary due to tip geometry. If the power is turned on while a Power Module is not installed, or if the Power Module is removed during operation, the system will turn itself off and the LED indicator light on the front panel will turn red. To operate the unit, please make sure the set-up procedure has been followed, then follow the procedure below. 1. Install the desired tip heater cartridge or tip. 2. Install the desired Power Module into the Power Port on the front of the unit. 3. The LED indicator will turn amber while the tip is heating to the desired performance level. 4. Once the tip has reached the desired heat level, the LED indicator will turn green and the system is ready to use. Auto-Setback and Auto-Off Features The ST 70 system comes standard with Auto-Setback and Auto-Off Features. These are pre- programmed for 30 minute Setback and 30 minute Auto Off, which can be turned off by the switch on the back of the unit. When Setback mode has been entered, the performance level will be adjusted to 3.5. Power Module Controlled LED Operation The colored LED on the power source front panel indicates Power Receptacle output status. LED Amber to Green - This condition is evident when the system is first powered up (handpiece heater cold). LED Green - Handpiece tip has reached set temperature. LED Red - Indicates an open sensor. Handpiece, Tip Heater Cartridge or power module has been removed. LED Off System is in auto-off mode or no power is being delivered to the handpiece heater. If the LED never illuminates, check for a faulty handpiece or tip heater cartridge. LED in Set back- The LED will be Amber or Green depending on the color when it entered Setback, or Auto Off. Replacement Power Modules 2006 PACE Inc., Annapolis Junction, Maryland All Rights Reserved Page 15 of 20 PACE Power Modules Part Number Color Series Nominal Temp 1207-0446-01-P1 Green 5 260 C (500 F) 1207-0446-02-P1 Turquoise 5.5 288 C (550 F) 1207-0446-03-P1 Orange 6 316 C (600 F) 1207-0446-04-P1 Gold 6.5 343 C (650 F) 1207-0446-05-P1 Red 7 371 C (700 F) 1207-0446-06-P1 Violet 7.5 399 C (750 F) 1207-0446-07-P1 Black 8 427 C (800 F) 1207-0446-08-P1 Silver 8.5 454 C (850 F) *Note: Each ST-70 system includes (1) each 6.5, 7.0, & 7.5 power modules 2006 PACE Inc., Annapolis Junction, Maryland All Rights Reserved Page 16 of 20