PEL00584 Pro Elec

Model No. PEL00584 MAINTAINED LED DOUBLE SIDED WALL MOUNT EMERGENCY LIGHT 1Please read these instructions carefully before starting installation and retain for future reference. The centre page test record can be removed and kept with the building fire safety records. IMPORTANT SAFETY INFORMATION RISK OF ELECTRICAL SHOCK. ALWAYS ISOLATE THE POWER AT THE MAINS BEFORE INSTALLING OR MAINTAINING THIS EMERGENCY LIGHT. This product must be installed by a competent person in accordance with the Building Regulations and the current edition of the IET Wiring Regulations (BS7671). This product is suitable for mounting on normally flammable surfaces such as wood, plasterboard or masonry. Emergency light fittings should have their own separate mains circuit, protected with an appropriate MCB or fuse. They should not share their supply with other lighting or electrical equipment. This product is suitable for connection to a 220-240V~ 50Hz. This product is for indoor use only. Ensure that after installation the equipment remains accessible for regular maintenance and testing. INSTALLATION NOTE: Before drilling any holes, check that there are no hidden obstructions behind the mounting surface such as pipes or cables and that the wall will bear the weight safely. 1. Offer up the product in the location required and mark the fastening positions on the wall (234mm between centres). 2. Drill the wall and fit appropriate wall plugs (not supplied) in preparation for mounting the sign after the wiring connections have been made. 3. Prize off the rear cover carefully using a flat blade screwdriver and feed the wiring through the hole provided in the cover. 4. Make connection to the supply using the terminal block provided. Ensure that the correct polarities are observed i.e.: Brown Live terminal L Blue Neutral terminal N. Link wire L to SW can be removed to change between maintained and non- maintained. 5. Write the current date on the battery pack in the space provided. 6. Connect the battery to the socket on the PCB marked BATTERY. 7. Refit the rear cover, making sure that it is securely clipped in place. 8. Feed the wiring along the retention groove in the cover and locate the product on the wall and attach with suitable screws into the wall plugs installed earlier. 9. Turn on the power supply. The green LED should light to indicate that the battery is charging. 10. In maintained mode, the lamp will illuminate. 11. Perform the electrical tests specified in the Wiring Regulations (BS7671). 2