PY-I-QUADTO39(7+1) (Rev. 4.0) Miniature Thin Film Four Channel Pyroelectric Sensor Introduction Unlike other pyroelectric materials, the Pyreos thin film pyroelectric sensors can be reduced in physical size and still provide high sensitivity with fast frequency operation, enabling this highly stable four element sensor in a TO39 package. This current mode sensor offers performance in a small footprint and up to 100 Hz data monitoring. The sensor has internal CMOS trans impedance amplifiers, with 10 G feedback resistors outputting voltage signals centred around half the supply rail. A range of IR filters are available. Sensor Characteristics Electrical Characteristics 2 Filter aperture 1.4 mm x 1.4mm Max. Voltage (+V) 5.0 V 2 Element size 700 m x 325 m Min. Voltage (+V) 2.7 V 2 Package TO39 Recommended Offset V (+V / 2) 1 Responsivity 100,000 V/W Microphonics S ~1 V/ g at 10Hz vib 1 8 D* 1.5 x 10 cmHz/ W Time Constant ~10 ms 1 Noise 40 uVHz Operating Temperature -40 to +85 C Op amp with 10 G feedback resistor Storage Temperature -40 to +110 C 2 Offset V max (+V) 0.1 V 2 Offset V min 0.1 V 1 10 Hz, 500 K, room temperature, without window and optics 2 With reference to GND Frequency Characteristics Please note: the information contained in this document is subject to change without further notification. Pyreos reserves the right to alter the performance and any resulting specification. Pyreos may choose not to supply any engineering sample devices as a commercial product. No responsibility is accepted for any consequential loss incurred. Pyreos Ltd, SMC, Alexander Crum Brown Road, Edinburgh EH9 3FF, UK. Tel: +441316507009, www.pyreos.com 1 PY-I-QUADTO39(7+1) (Rev. 4.0) Package Information Filter window size Note: Ensure that the sensor base is not in contact with the PCB in order to avoid shorts. Recommended Circuit Diagram Please note: the information contained in this document is subject to change without further notification. Pyreos reserves the right to alter the performance and any resulting specification. Pyreos may choose not to supply any engineering sample devices as a commercial product. No responsibility is accepted for any consequential loss incurred. Pyreos Ltd, SMC, Alexander Crum Brown Road, Edinburgh EH9 3FF, UK. Tel: +441316507009, www.pyreos.com 2 Package dimensions Top View Internal Schematic Bottom View