Technical Data Sheet SPDT Ramses Low PIM N 12.4GHz Failsafe Indicators 12Vdc TTL Diodes Pins Terminals PAGE 1/2 ISSUE 22-09-15 SERIE : SPDT PART NUMBER : R570122100LP RF CHARACTERISTICS Frequency range : 0 - 12.4 GHz Impedance : 50 Ohms Frequency (GHz) DC - 1 1 - 2 2 - 3 3 - 8 8 - 12.4 VSWR max 1.15 1.20 1.25 1.35 1.50 Insertion loss max 0.15 dB 0.20 dB 0.25 dB 0.35 dB 0.50 dB Isolation min 85 dB 80 dB 75 dB 70 dB 60 dB Average power (*) 700 W 500 W 400 W 250 W 200 W Passive intermodulation Tone 1 1810 MHz, approximately 43 dBm Tone 2 1850 MHz, approximately 43 dBm rd 3 order PIM - 160 dBc at 1770 MHz Depending on application, carrier powers and frequencies, PIM measurements can vary. PIM testing is not measured during product acceptance test. ELECTRICAL CHARACTERISTICS Actuator : FAILSAFE Nominal current ** : 320 mA Actuator voltage (Vcc) : 12V (10.2 to 13V) Terminals : solder pins (250C max. / 30 sec.) Indicator rating : 1 W / 30 V / 100 mA TTL inputs (E) - High level : 2.2 to 5.5 V / 800A at 5.5 V - Low level : 0 to 0.8 V / 20A at 0.8 V MECHANICAL CHARACTERISTICS Connectors***** : N female per MIL-C 39012 Life : 2 million cycles Switching Time*** : < 15 ms Construction : Splashproof Weight : < 185 g ENVIRONMENTAL CHARACTERISTICS Operating temperature range : -25C to +70C Storage temperature range : -55C to +85C (* Average power at 25C per RF Path) (** At 25 C 10%) (*** Nominal voltage 25 C) (***** Recommended mating torque: 300 N.cm This document contains proprietary information and such information shall not be disclosed to any third party for any purpose whatsoever or used for manufacturing purposes without prior written agreement from Radiall. The data defined in this document are given as an indication, in the effort to improve our products we reserve the right to make any changes judged necessary.Technical Data Sheet SPDT Ramses Low PIM N 12.4GHz Failsafe Indicators 12Vdc TTL Diodes Pins Terminals PAGE 2/2 ISSUE 22-09-15 SERIE : SPDT PART NUMBER : R570122100LP DRAWING LABEL RADIALL R570122100LP 0 - 12.4 GHz / Un : 12V Lot : General tolerances : 0.5 mm SCHEMATIC DIAGRAM TTL input RF Continuity Ind. E = 0 C NC C.1NC E = 1 C NO C.2NO This document contains proprietary information and such information shall not be disclosed to any third party for any purpose whatsoever or used for manufacturing purposes without prior written agreement from Radiall. The data defined in this document are given as an indication, in the effort to improve our products we reserve the right to make any changes judged necessary.