R577432000LP Radiall

Technical Data Sheet DPDT Ramses Low PIM SMA 18GHz Latching 12Vdc Pins Terminals with bracket PAGE 1/2 ISSUE 05-06-15 SERIE : DPDT PART NUMBER : R577432000LP RF CHARACTERISTICS Frequency range : 0 - 18 GHz Impedance : 50 Ohms Frequency (GHz) DC - 3 3 - 8 8 - 12.4 12.4 - 18 VSWR max 1.20 1.30 1.40 1.50 Insertion loss max 0.20 dB 0.30 dB 0.40 dB 0.50 dB Isolation min 80 dB 70 dB 65 dB 60 dB Average power (*) 240 W 150 W 120 W 100 W Passive intermodulation Tone 1 1810 MHz, approximately 43 dBm Tone 2 1850 MHz, approximately 43 dBm rd 3 order PIM - 160 dBc at 1770 MHz Depending on application, carrier powers and frequencies, PIM measurements can vary. PIM testing is not measured during product acceptance test. ELECTRICAL CHARACTERISTICS Actuator : LATCHING Nominal current ** : 320 mA Actuator voltage (Vcc) : 12V (10.2 to 13V) / NEGATIVE COMMON Terminals : solder pins (250C max. / 30 sec.) MECHANICAL CHARACTERISTICS Connectors***** : SMA female per MIL-C 39012 Life : 2 million cycles Switching Time*** : < 15 ms Construction : Splashproof Weight : < 100 g ENVIRONMENTAL CHARACTERISTICS Operating temperature range : -25C to +70C Storage temperature range : -55C to +85C (* Average power at 25C per RF Path) (** At 25 C 10%) (*** Nominal voltage 25 C) (***** Recommended mating torque: 80-120 N.cm This document contains proprietary information and such information shall not be disclosed to any third party for any purpose whatsoever or used for manufacturing purposes without prior written agreement from Radiall. The data defined in this document are given as an indication, in the effort to improve our products we reserve the right to make any changes judged necessary.Technical Data Sheet DPDT Ramses Low PIM SMA 18GHz Latching 12Vdc Pins Terminals with bracket PAGE 2/2 ISSUE 05-06-15 SERIE : DPDT PART NUMBER : R577432000LP DRAWING LABEL RADIALL R577432000LP 0 - 18 GHz Un : 12V Lot : General tolerances : 0.5 mm SCHEMATIC DIAGRAM Voltage RF Continuity -C +1 1 3 / 2 4 -C +2 1 2 / 3 4 This document contains proprietary information and such information shall not be disclosed to any third party for any purpose whatsoever or used for manufacturing purposes without prior written agreement from Radiall. The data defined in this document are given as an indication, in the effort to improve our products we reserve the right to make any changes judged necessary.