3
SIGNAL LAMPS
Signal lamps with integrated LED 3 - 3
Signal lamp with integrated LED - 5 mm, solder terminals 3 - 5
Signal lamp with integrated LED - 7 mm, solder terminals 3 - 9
Signal lamp with integrated LED - 9.1 mm, solder terminals 3 - 11
Signal lamp with integrated LED - 10 mm, quick-connect terminal 3 - 13
Signal lamp with integrated LED - 11.1 mm, solder terminals 3 - 16
Signal lamp with integrated LED - 16.2 mm, quick-connect terminal 3 - 18
Signal lamp with integrated LED - 16.2 mm, screw terminals 3 - 20
Signal lamp with integrated LED - 18,2 mm, quick-connect terminal 3 - 23
Signal lamp with integrated LED - 22.3 mm, screw terminals 3 - 25
Signal lamp with integrated LED - 30.5 mm, quick connector 3 - 27
3 - 31
Signal lamps with integrated lamp
Signal lamp with integrated neon lamp - 7 mm, solder terminals 3 - 33
Signal lamp with integrated neon lamp - 10 mm, quick-connect terminal 3 - 35
Signal lamp with integrated neon lamp - 10 mm, quick-connect terminal 3 - 37
Signal lamp with integrated neon lamp - 14 mm, quick-connect terminal 3 - 40 SIGNAL LAMPS
GENERAL INFORMATION
Signal Lamps with integral lamps/LED Standard mounting dimensions
The soldered lamps/LED without base cannot be We recommend use of mounting hole diameters 16, 22
replaced. and 30 mm, as these comply with international standard
recommendations and DIN standards.
Signal Lamps with lamp socket
An integral lamp socket allows replacement of lamps/LED Limit values
of the appropriate type. The voltage specified as the limit value is the standard
insulating voltage for the signal lamps. The permitted
Filament operating life ambient temperatures are always specified in conjunction
Operating life specifications refer to AC voltage operation. with the maximum power of the lamps used, and the
If operated with DC voltage, these values are reduced by signal lamp should be located outside of the space sub-
40%. ject to increased temperature.
Color and lenses
transparent = clear, grooved on inner surface for better
light diffusion
opaque = translucent
but not clear
Neon lamps
Neon lamps may glow on a short time after having been To avoid this, a parallel resistor with 1,2 M 1/4 W, can be
switched off, for example in combination with long wires. used.
3
3-2