Instruction Sheet STS-M-FER-01 Scissor Action Hand Tool Rev. A CAT-RF-FER-01 Date: 10/21/2014 Introduction Scissor Action Hand Tool CAT-RF-FER-01 was designed to crimp all Samtec series with RF hex crimps. This tool should only be used for Samtec RF assemblies. The tool is not adjustable. Variation in production batches of tools, connectors, wire stranding and insulation types may affect crimp parameters. Crimping Procedure 1. Place the non-crimped ferrule in the proper position on the RF assembly. 2. Squeeze the handles until the tool ratchet releases, allowing the handles to fully open (Figure 1). 3. Place RF assembly, with ferrule still in proper position, into the tool jaws (Figure 2). Be sure to correctly align the ferrule within the desired crimp profile. 4. Partially close the handles until the tool has a good hold on the ferrule of the RF Figure 1 assembly. 5. Using both hands, close the handles together until the ratchet mechanism has completed the cycle and the handles release to the fully opened position. 6. Remove the crimped assembly from the tool. CAUTION: Should an assembly become stuck or jammed in a partially closed position, DO NOT use force to open or close the handles. The tool will easily open by pushing Figure 2 the ratchet release lever up (Figure 3). Samtec, Inc. CUSTOMER SERVICE +1-800-726-8329 (+1-812-944-6733) Page 1 Instruction Sheet STS-M-FER-01 Scissor Action Hand Tool Rev. A CAT-RF-FER-01 Date: 10/21/2014 Figure 3 Die Set Installation 1. Remove die screws from frame using T20 Torx wrench (See Figure 4). 2. Insert die sets into frame, and install die screws but do not tighten. 3. Close handles and make sure dies are properly aligned, and then fully tighten die screws. Inspection It is recommended that a maintenance and inspection program be performed periodically to ensure dependable and uniform terminations. Frequency of inspection depends on: The care, amount of use, and handling of the hand tool, Figure 4 The presence of abnormal amounts of dust and dirt, Your own established standards. The hand tool is inspected before being shipped however, it is recommended that the tool be inspected immediately upon its arrival at your facility to ensure that the tool has not been damaged during shipment. Samtec, Inc. CUSTOMER SERVICE +1-800-726-8329 (+1-812-944-6733) Page 2