8.06.13 J-LINK MEASUREMENT+PATCH ADAPTER Segger Microcontroller

J-Link Debug Probes Adapters Measurement+Patch Adapter J-Link Measurement+Patch Adapter The J-Link Patch Adapter allows easy customized wiring between J-Link and targets that do not provide a standard debug connector that fits to any of the adapters available for J-Link (e.g. the Discovery Boards from ST Microelectronics). It comes with a set of colored jumper wires, allowing easy differentiation of the debug signals. The J-Link Patch Adapter also provides test points for all debug signals to allow easy access to them for checking signal integrity. It has a standard 20-pin 0.1 socket towards the J-Link debug probe and a standard 20-pin 0.1 header on the target side, so it can be plugged-in directly to J-Link, maintaining a 1:1 connection. For increased flexibility VTref on pin 1 and the target supply voltage on pin 19 can be interrupted by means of two jumpers. Click to enlarge Click to enlarge J-Link Measurement+Patch Adapter in use Head office Germany Phone: +49-2103-2878-0 Fax: +49-2103-2878-28 E-mail: info segger.com www.segger.com US office Phone: +1-978-874-0299 Fax: +1-978-874-0599 E-mail: info segger-us.com www.segger-us.com Click to enlarge SEGGER - The Embedded Experts - Measurement+Patch Adapter Click to enlarge Imprint Disclaimer Sitemap back to top 2014, www.segger.com, All rights reserved.