M25PXX 512 Kbit to 32 Mbit, Low Voltage, Serial Flash Memory With 40 MHz or 50 MHz SPI Bus Interface DATA BRIEF FEATURES SUMMARY 512Kbit to 32Mbit of Flash Memory Figure 1. Packages Page Program (up to 256 Bytes) in 1.4ms (typical) Sector Erase (256 Kbit or 512Kbit) Bulk Erase (512Kbit to 32Mbit) 2.7 to 3.6V Single Supply Voltage VDFPN8 (ME) SPI Bus Compatible Serial Interface 8x6mm (MLP8) 40MHz to 50MHz Clock Rate (maximum) Deep Power-down Mode 1 A (typical) Electronic Signatures JEDEC Standard Two-Byte Signature (20xxh) RES Instruction, One-Byte, Signature, for backward compatibility VDFPN8 (MP) More than 100000 Erase/Program Cycles per (MLP8) Sector More than 20 Year Data Retention Table 1. Product List Reference Part Number M25P32 M25P16 SO16 (MF) M25P80 300 mil width M25Pxx M25P40 M25P20 8 M25P10-A M25P05-A 1 SO8 (MN) 150 mil width October 2004 1/7 For further information contact your local ST sales office. M25PXX Figure 3. SO8 and VDFPN Connections SUMMARY DESCRIPTION The M25Pxx is a 512Kbit to 32Mbit (2M x 8) Serial Flash Memory, with advanced write protection mechanisms, accessed by a high speed SPI-com- patible bus. The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction. M25Pxx The memory is organized as a number of sectors, each containing 256 or 128 pages. Each page is SV1 8 CC 256 bytes wide. Q 2 7 HOLD The whole memory can be erased using the Bulk W 3 6 C Erase instruction, or a sector at a time, using the V 4 5 D SS Sector Erase instruction. AI10259 Figure 2. Logic Diagram V CC D Q Note: 1. There is an exposed die paddle on the underside of the MLP8 package. This is pulled, internally, to V , and SS C must not be allowed to be connected to any other voltage or signal line on the PCB. S M25Pxx Figure 4. SO16 Connections W M25Pxx HOLD HOLD 1 16 C V 2 15 D CC DU 3 14 DU V SS AI10258 DU 4 13 DU DU 5 12 DU DU 6 11 DU S 7 10 V SS Table 2. Signal Names Q 8 9 W C Serial Clock AI10260 D Serial Data Input Note: 1. DU = Dont Use Q Serial Data Output Chip Select S W Write Protect HOLD Hold V Supply Voltage CC V Ground SS 2/7