STM32F779I-EVAL Evaluation board with STM32F779NI MCU Data brief Features STM32F779NI microcontroller with 2-Mbyte Flash memory and 512+16+4-Kbyte RAM in BGA216 package Six 5 V power supply options: Power jack ST-LINK/V2-1 USB Micro-B connector User USB HS connector User USB FS1 connector User USB FS2 connector Daughterboard SAI audio DAC, stereo audio jack that supports headset with microphone Stereo digital microphone, audio jack connector used to connect external speakers 2-Gbyte (or more) SDIO interface microSD card 1. Picture not contractual. 2 USB OTG HS and FS with Micro-AB Four I C interfaces connectors RS-232 communication RTC with backup battery JTAG/SWD and ETM trace debug support, CAN2.0A/B compliant connection ST-LINK/V2-1 embedded Potentiometer IEEE-802.3-2002 compliant Ethernet connector Motor control connector Camera module 8Mx32bit SDRAM, 1Mx16bit SRAM and 8Mx16bit NOR Flash 512-Mbit Quad-SPI NOR Flash 2Gx16bit NAND Flash interface to connect NAND Flash module 4 DSI interface LCD with capacitive touch panel Joystick with 4-direction control and selector Reset, Wake Up/Tamper or key button 4-color user LEDs Extension and memory connectors for daughterboard or wrapping board April 2016 DocID029091 Rev 1 1/4 For further information contact your local STMicroelectronics sales office. www.st.comDescription STM32F779I-EVAL 1 Description The STM32F779I-EVAL evaluation board is a complete demonstration and development platform for STMicroelectronics ARM Cortex -M7 core-based STM32F779NI 2 microcontrollers. It features the following interfaces: four I Cs, six SPIs with three 2 multiplexed full-duplex I S, SDIO, two SAIs, 8- to 14-bit digital camera module, Ethernet MAC, FMC and Quad-SPI. It also features four USART and four UART peripherals, two CAN bus, three 12-bit ADC converters, two 12-bit DAC channels, internal 256+4-Kbyte SRAM and 2-Mbyte Flash memory, USB HS OTG and USB FS OTG peripherals, JTAG debugging support. This evaluation board can be used as a reference design for user application development but it is not considered as a final application. The full range of hardware features on the board helps the user to evaluate all the peripherals (USB OTG HS, USB OTG FS, Ethernet, motor control, CAN, microSD card, USART, audio DAC and ADC, digital microphone, CAN, SRAM, NOR Flash, SDRAM, Quad SPI Flash, 4 DSI LCD with capacitive touch panel, etc.) and to develop applications. Extension headers make it possible to easily connect a daughterboard for a specific application. The integrated ST-LINK/V2-1 provides an embedded in-circuit debugger and programmer for the STM32. 2 Ordering information To order the evaluation board with the STM32F779NI MCU, use the order code STM32F779I-EVAL. 2/4 DocID029091 Rev 1