TAR5S33UTE85LF

TAR5S15U~TAR5S50U TOSHIBA Bipolar Linear Integrated Circuit Silicon Monolithic TAR5S15U ~ TAR5S50U Point Regulators (Low-Dropout Regulators) The TAR5SxxU Series consists of general-purpose bipolar LDO regulators with an on/off control pin and features overtemperature and overcurrent protection circuits. Features Low standby current Overtemperature and overcurrent protections Wide operating voltage range SON5-P-0202-0.65 High maximum output current (UFV) Low input-to-output voltage differential Weight: 0.007 g (typ.) Small package (UFV package similar to SOT-353) Allows use of ceramic capacitors as the input and output capacitors. Pin Assignment (Top View) V V IN OUT 5 4 1 2 3 CONTROL GND NOISE The overtemperature and overcurrent protection features are not intended to guarantee correct operation below the absolute maximum ratings. Do not use the TAR5SxxU under conditions where the absolute maximum ratings may be exceeded. Start of commercial production 2001-08 1 2014-03-01 TAR5S15U~TAR5S50U List of Part Numbers and Markings Part Marking Example: TAR5S30U (3.0-V output) Part No. Marking Part No. Marking TAR5S15U 1V5 TAR5S33U 3V3 TAR5S16U 1V6 TAR5S34U 3V4 3 V 0 TAR5S17U 1V7 TAR5S35U 3V5 TAR5S18U 1V8 TAR5S36U 3V6 TAR5S19U 1V9 TAR5S37U 3V7 TAR5S20U 2V0 TAR5S38U 3V8 TAR5S21U 2V1 TAR5S39U 3V9 TAR5S22U 2V2 TAR5S40U 4V0 TAR5S23U 2V3 TAR5S41U 4V1 TAR5S24U 2V4 TAR5S42U 4V2 TAR5S25U 2V5 TAR5S43U 4V3 TAR5S26U 2V6 TAR5S44U 4V4 TAR5S27U 2V7 TAR5S45U 4V5 TAR5S28U 2V8 TAR5S46U 4V6 TAR5S29U 2V9 TAR5S47U 4V7 TAR5S30U 3V0 TAR5S48U 4V8 TAR5S31U 3V1 TAR5S49U 4V9 TAR5S32U 3V2 TAR5S50U 5V0 Absolute Maximum Ratings (Ta = 25C) Characteristics Symbol Rating Unit Supply Voltage V 15 V IN Output Current I 200 mA OUT Power Dissipation P 450 (Note 1) mW D Operation Temp. Range T 40 to 85 C opr Storage Temp. Range T 55 to 150 C stg Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (Handling Precautions/Derating Concept and Methods) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). 2 Note 1: Mounted on a glass epoxy circuit board of 30 mm 30 mm Pad dimension of 35 mm 2 2014-03-01