TC74HC14AP/AF/AFN TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic TC74HC14AP,TC74HC14AF,TC74HC14AFN Hex Schmitt Inverter Note: xxxAFN (JEDEC SOP) is not available in Japan. The TC74HC14A is a high speed CMOS SCHMITT 2 TC74HC14AP INVERTER fabricated with silicon gate C MOS technology. It achieves the high speed operation similar to equivalent LSTTL while maintaining the CMOS low power dissipation. Pin configuration and function are the same as the TC74HC04A but the inputs have 25% V hysteresis and with its schmitt trigger CC function, the TC74HC14A can be used as a line receivers which will receive slow input signals. All inputs are equipped with protection circuits against static discharge or transient excess voltage. TC74HC14AF Features High speed: t = 11 ns (typ.) at V = 5 V pd CC Low power dissipation: I = 1 A (max) at Ta = 25C CC High noise immunity: V = 1.1 V at V = 5 V H CC Output drive capability: 10 LSTTL loads Symmetrical output impedance: I = I = 4 mA (min) OH OL Balanced propagation delays: t t pLH pHL TC74HC14AFN Wide operating voltage range: V (opr) = 2~6 V CC Pin and function compatible with 74LS14 Pin Assignment Weight DIP14-P-300-2.54 : 0.96 g (typ.) SOP14-P-300-1.27A : 0.18 g (typ.) SOL14-P-150-1.27 : 0.12 g (typ.) IEC Logic Symbol 1 2007-10-01 TC74HC14AP/AF/AFN Truth Table A Y L H H L System Diagram, Waveform Absolute Maximum Ratings (Note 1) Characteristics Symbol Rating Unit Supply voltage range V 0.5~7 V CC DC input voltage V 0.5~V + 0.5 V IN CC DC output voltage V 0.5~V + 0.5 V OUT CC Input diode current I 20 mA IK Output diode current I 20 mA OK DC output current I 25 mA OUT DC V /ground current I 50 mA CC CC Power dissipation P 500 (DIP) (Note 2)/180 (SOP) mW D Storage temperature T 65~150 C stg Note 1: Exceeding any of the absolute maximum ratings, even briefly, lead to deterioration in IC performance or even destruction. Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (Handling Precautions/Derating Concept and Methods) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note 2: 500 mW in the range of Ta = 40C~65C. From Ta = 65C to 85C a derating factor of 10 mW/C shall be applied until 300 mW. Operating Ranges (Note) Characteristics Symbol Rating Unit Supply voltage V 2~6 V CC Input voltage V 0~V V IN CC Output voltage V 0~V V OUT CC Operating temperature T 40~85 C opr Note: The operating ranges must be maintained to ensure the normal operation of the device. Unused inputs must be tied to either VCC or GND. 2 2007-10-01