JHM1512D15 XP Power

DC-DC Converter JHM15 Series 15 Watts International Medical Approvals xxx Series 4000 VAC Reinforced Insulation Medical Approval, IEC60601-1, 3rd Edition 2 A Patient Leakage Current Compact 1 x 1.6 Footprint EN55011 Level A With No External Components 3 Year Warranty Dimensions: JHM15: 1.60 x 1.00 x 0.40 (40.60 x 25.40 x 10.20 mm) Models & Ratings Input Current Maximum (4) Input Voltage Output Voltage Output Current Efficiency Model Number (3) (1) (2) Capacitive Load No Load Full Load 5.0 V 3000 mA 9.2 mA 1930 mA 3000 F 87% JHM1512S05 12.0 V 1250 mA 6.5 mA 1938 mA 1330 F 86% JHM1512S12 15.0 V 1000 mA 8.0 mA 1944 mA 1000 F 86% JHM1512S15 9-18 V 5.0 V 1500 mA 6.6 mA 1955 mA 1470 F 84% JHM1512D05 12.0 V 625 mA 11.2 mA 1911 mA 660 F 87% JHM1512D12 15.0 V 500 mA 11.0 mA 1879 mA 550 F 88% JHM1512D15 5.0 V 3000 mA 5.6 mA 972 mA 3000 F 86% JHM1524S05 12.0 V 1250 mA 6.1 mA 968 mA 1830 F 85% JHM1524S12 15.0 V 1000 mA 6.4 mA 966 mA 1000 F 87% JHM1524S15 18-36 V 5.0 V 1500 mA 5.4 mA 981 mA 1470 F 83% JHM1524D05 12.0 V 625 mA 7.3 mA 954 mA 660 F 87% JHM1524D12 15.0 V 500 mA 8.5 mA 943 mA 550 F 87% JHM1524D15 Notes 1. Input current measured at nominal input voltage. 3. Maximum capacitive load is per output. 2. Input current measured at lowest input voltage. 4. Typical values. Mechanical Details 0.400 (10.16) 0.200 (5.08) Pin Connections 0.200 (5.08) Pin Single Dual 0.100 (2.54) 1 +Vin +Vin 2 -Vin -Vin 6 2 1 3 +Vout +Vout 4 -Vout Common 5 Trim -Vout 6 No Pin No Pin BOTTOM VIEW Notes 1. All dimensions are in inches (mm) 2. Weight: 0.04 lbs (20 g) approx. 3. Pin diameter: 0.04 0.002 (1.02 0.05) 0.040 (1.02) 4. Pin pitch tolerance: 0.01 (0.25) 5 4 3 5. Case tolerance: 0.02 (0.5) 0.100 (2.54) 0.40 (10.2) 0.22 (5.6) min 0.400 (10.16) 0.400 (10.16) 1.00 (25.4) www.xppower.com 1 1.60 (40.6) 1.40 (35.56)DC-DC Converter JHM15 Series Input Characteristic Minimum Typical Maximum Units Notes & Conditions Input Voltage Range 9 18 VDC 12 V nominal 18 36 VDC 24 V nominal Input Current See Models and Ratings table Inrush Current 70 A at 36 V Input Filter Pi type Patient Leakage Current 2 A On at >8.8 V. Off <8.3 V 12 V models Undervoltage Lockout On at >17.5 V. Off <17.0 V 24 V models 25 VDC 12 V models for 3 s Input Surge 50 VDC 24 V models for 3 s Output Characteristic Minimum Typical Maximum Units Notes & Conditions Output Voltage 5 15 V See Models and Ratings table Output Voltage Trim 10 % Via external resistors, see Application Notes 1 % on V1 Initial Set Accuracy 2 % on V2 of dual output models Minimum Load 0A No minimum load required Start Up Delay 25 ms Start Up Rise Time 22 ms Line Regulation 0.3 % 2 % 0 - 10% load Load Regulation 1 % 10 - 100% load On dual output models with one output set to 50% load and Cross Regulation 4 % the other varied from 10% to 100% load (D05 20% to 100%) Recovery to within 1% in <500 s for a 50% load change Transient Response 4 % deviation at 0.25 A/s rate Ripple & Noise 1 % pk-pk 20 MHz bandwidth Short Circuit Protection Trip & Restart (hiccup mode), auto recovery Overload Protection 120 200 % Trip & Restart (hiccup mode) Overvoltage Protection 115 140 % Non latching, auto recovery Temperature Coefficient 0.03 %/ C General Characteristic Minimum Typical Maximum Units Notes & Conditions Efficiency 86 % See Models and Ratings table For 1 min. Double/reinforced with a working voltage of 250 Isolation 4000 VAC VAC. Meets 2 x MOPP per 3rd edition of IEC60601-1 5000 VAC for 10 ms in accordance with IEC60664-1 Input to Output Capacitance 20 pF Switching Frequency 250 kHz 3 Power Density 23 W/in Mean Time Between Failure >1 MHrs MIL-HDBK-217F, +25 C GB Weight 0.04 (20.0) lb (g) Environmental Characteristic Minimum Typical Maximum Units Notes & Conditions Operating Temperature -40 +80 C See derating curve Storage Temperature -55 +100 C Case Temperature +100 C Humidity 5 90 %RH Non-condensing Cooling Natural convection Shock 3 shocks in each plane, total 18 shocks of 30 g : 11 ms halfsine. Conforms to EN60068-2-27 & EN60068-2-47 Vibration 10-500 Hz at 2 g sweep and endurance at resonance in all 3 planes. Conforms to EN60068-2-6 www.xppower.com 2