AN820001 ZF Cherry

Angle Position Sensors AN8 Sensors Programmable, non-contact magnetic position sensors capable of continuous rotation Description The AN8 Series sensors are non-contact, intrinsically linear angle position sensors. The sensors operate through the use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a linear change in voltage output (ratiometric to the input voltage) corresponding to an angular rotation of the input shaft. Features Typical Applications Angular position sensor with high tolerance for misalignment Implement (fork lift, agricultural trailer hitch, Non-contact angular position sensing and full 360 rotation etc.) position sensing Custom programming available for: angle range, slope, PWM Steer, throttle by wire output, custom magnets contact factory Gear selection No mechanical interface means no parts to wear out or jam Zero-contact encoder alternative Available with Delphi connector or 12 (305 mm) wire leads Replacement for smart bearings RoHS compliant Outboard trim sensing IP67 Maximum air gap of 5.5 mm (0.22)* Environmental Specifications Vibration 6g sinusoidal, 8 g RMS axial 40Hz 2 kHz all 3 axes Operating Temperature -40 C to 125 C (-40 F to 257 F) with Delphi connectors, -40 C to 150 C (-40 F to 302 F) with wire leads Storage Temperature -40 C to 150 C (-40 F to 302 F) Ingress Protection IP67 Electrical Specifications Input Voltage 5.0 VDC 10% Output Voltage 10% to 90% of input (see graph for voltage vs. rotation angle characteristics) Input Current 14 mA typ., 16 mA max. Output Current -8 mA to 8 mA Output Accuracy 3.5% Output Linearity 3.5% Maximum Overvoltage 16 VDC Absolute Max. Output Current 30 mA Output Type Analog (PWM available) Mechanical Specifications Housing Material Glass Reinforced Plastic Mechanical Travel 0 to 360 (continuous) Mating Connector Delphi Metri-pak 150.2 12162185 Terminal 1214075 / 2047680 Maximum Air Gap* 5.5 mm (0.22 ) *with AS500106 magnet carrier Maximum Center-To-Center Offset 2 mm radial (magnet to center) www.cherryswitches.com Page 1 of 2, last update 2015-03-16, Specifications subject to change without notice. Products Part Number Sensor (incl. Sensing Wires Connectors Terminals (Sensor) AS500106 magnet) Range AN820001 CU103601 180 N/A Packard Metri-pack 1214075 / 2047680 AN820002 CU103602 360 N/A Packard Metri-pack 1214075 / 2047680 AN820003* CU103603 45 N/A Packard Metri-pack 1214075 / 2047680 AN820031 -------- 180 18 AWG x 305 mm (12 ) N/A N/A AN820032 -------- 360 18 AWG x 305 mm (12 ) N/A N/A AN820033* -------- 45 18 AWG x 305 mm (12 ) N/A N/A *Not commonly stocked Sensor Output These charts show the output voltage as a percentage of the input voltage for a given angle of rotation. Example: 180 sensing range, magnet rotated 135, output voltage will be 70% of input voltage (see dashed lines in graph above). Dimensions mm (inches) www.cherryswitches.com Page 2 of 2, last update 2015-03-16, Specifications subject to change without notice.