Click on Series name for product info on aimtec.com Series AMEPR30C-AZ up to 2.5A AC-DC / DC-DC LED Driver / Converter FEATURES: AC-DC Constant Current or Constant Over temperature protection Voltage LED Driver Over current protection Input range 90-305VAC/47-440Hz Waterproof case rated IP68 High efficiency up to 83% Power Factor Correction Operating temperature -40 to 85C Short circuit protection Dimmable via resistive / 0-10Vdc / PWM Models 5 Years Limited Warranty Single output Max Output Efficiency Output Input Input Output Voltage (%) Current Model Voltage Voltage Mode of Operation Power Range 115 230 277 (VAC/Hz) (VDC) (A) VAC VAC VAC (W) (V) Constant Current 83 83 83 AMEPR30C-5070AZ 35 36-50 0.7 90-305/47-440 130-430 Constant Voltage 83 83 83 Constant Current 83 83 83 AMEPR30C-4864AZ 30.7 36-48 0.64 90-305/47-440 130-430 Constant Voltage 83 83 83 Constant Current 83 83 83 AMEPR30C-36100AZ 36 24-36 1 90-305/47-440 130-430 Constant Voltage 83 83 83 Constant Current 82 82 82 AMEPR30C-24140AZ 33.6 12-24 1.4 90-305/47-440 130-430 Constant Voltage 82 82 82 Constant Current 80 80 80 AMEPR30C-12250AZ 30 5-12 2.5 90-305/47-440 130-430 Constant Voltage 80 80 80 Exceeding the maximum output power will permanently damage the converter. . In constant current mode output current is maximum shown, in constant voltage mode output voltage is the maximum shown. All models can be ordered with optional North American colour input wires (black (L), white (N), green (GND)). Add NA to part number when ordering. NOTE: Aimtec limited warranty of 5 years is valid based on product operation at datasheet specifications at ambient temperature of 25C, humidity<75%, nominal input voltage (115/230/277VAC) and at rated output load unless otherwise specified. See Series AMEPR30C-AZ up to 2.5A AC-DC / DC-DC LED Driver / Converter Output Specifications Parameters Conditions Typical Maximum Units Current accuracy 3 % Line regulation (LL-HL) 2 % Load regulation 0-100% load 3 % Ripple & Noise* 100 mV p-p Hold-up time 50 ms Current adjustment range 100-10 % *Ripple and Noise are measured at 20MHz bandwidth by using a 0.1 F (M/C) or (C/C) and 47F (E/C) parallel capacitor. Isolation Specifications Parameters Conditions Typical Rated Units I/O 3sec 3750 VAC Tested voltage I/FG 2000 VAC O/FG 500 VAC Isolation Resistance 500VDC >1000 M General Specifications Parameters Conditions Typical Maximum Units Switching frequency 130 KHz Over current protection 105 % Over voltage protection Refer to Constant Current vs. Constant Voltage Mode curve Short circuit protection Auto recovery o Over temperature protection Detect case temperature 125C C o Operating temperature With derating over C Refer to model application C o Maximum case temperature 100 C o Storage temperature -40 to +95 C o Temperature coefficient 0.02 % / C Cooling Free air convection Humidity Non condensing 20~95 % RH Case material Plastic Potting Epoxy (IP68 rated) Wires UL1015 18AWG * 20CM Weight 530 g Dimensions 137.33 x 60 x 40.50 mm (5.41 x 2.36 x 1.59 inches) MTBF >400,000 hrs (MIL-HDBK-217F at t=+25C) Safety Specifications Parameters Agency approvals cULus, CE UL8750, UL60950-1, EN55022, class B, EN60529(IP68), EN61347-1, EN61347-2-13 Information Technology Equipment EN55022 Class B Harmonic Current Emissions IEC/EN 61000-3-2, Class C Voltage fluctuations and flicker IEC/EN 61000-3-3, (EN60555-3) Electrostatic Discharge Immunity IEC 61000-4-2 Level 3 Standards RF, Electromagnetic Field Immunity IEC 61000-4-3 Level 2 Electrical Fast Transient / Burst Immunity IEC 61000-4-4 Level 2 Surge Immunity IEC 61000-4-5 Level 3 RF, Conducted Disturbance Immunity IEC 61000-4-6 Level 2 Power frequency Magnetic Field Immunity IEC 61000-4-8 Level 1 Voltage dips, Short Interruptions Immunity IEC 61000-4-11 www.aimtec.com Tel: +1 514 620 2722 Toll free: + 1 888 9 AIMTEC (924 6832) F 052.1e R3.F 2 of 17 North America only