RoHS Recast Compliant SATA-Disk Module 5A-M SDM5A-M 7P/270D N1 Product Specifications (Toshiba 15nm) December 19, 2017 Version 1.3 Apacer Technology Inc. 1F, No.32, Zhongcheng Rd., Tucheng Dist., New Taipei City, Taiwan, R.O.C Tel: +886-2-2267-8000 Fax: +886-2-2267-2261 www.apacer.com Features: Standard Serial ATA Interface Temperature Range Serial ATA Revision 3.1 Operating: SATA 6.0 Gbps interface Standard: 0C to 70C ATA-8 command set Extended: -40C to 85C Backward compatible with SATA 1.5/3.0 Storage: -40C to 100C Gbps Supply Voltage Capacity 5.0 V 5% 8, 16, 32, 64 GB Power Consumption* Performance* Active mode: 205 mA Burst read/write: 600 MB/sec Idle mode: 80 mA Sequential read: Up to 245 MB/sec Connector Type Sequential write: Up to 75 MB/sec 7-pin SATA signal connector Flash Management 15-pin SATA power connector Built-in hardware ECC Form Factor Global Wear Leveling SATA Disk Module: 7-pin/270 degree N1 Flash bad-block management Dimensions: 52.5x23.0x15.2**, unit: mm Flash Translation Layer: Page Mapping S.M.A.R.T. Shock & Vibration** Power Failure Management Shock:1,500 G ATA Secure Erase Vibration: 15 G NAND Flash Type: MLC Write Protect Switch (optional) MTBF: >1,000,000 hours RoHS Recast Compliant Endurance (in Terabytes Written: TBW) Complies with 2011/65/EU Standard 8 GB: 11 TBW 16 GB: 22 TBW 32 GB: 39 TBW 64 GB: 48 TBW *Varies from capacities. The values for performances and power consumptions presented are typical and may vary depending on flash configurations or platform settings. The term idle refers to the standby state of the device. **Non-operating 1 2017 Apacer Technology Inc.