04-Serie G-A 04-Serie G-A 21/11/12 18:25 Page8 G series Slide switches - telecom grade Distinctive features and specifications Panel and PC mount models 6 actuator lengths Wide variety of contact materials ELECTRICAL SPECIFICATIONS Max. current/voltage rating with resistive load : - silver contacts (codes 1 or 2) : 3A 30VDC - gold plated brass contacts (code 0) : 0,4VA 20VAC or DC max. Initial contact resistance : 10 m Insulation resistance : 1.000 M min. Dielectric strength : 1.000 Vrms 50 Hz min. Electrical life with resistive load : - silver contacts (codes 1 or 2) : 2 positions : 40.000 cycles 3 positions : 20.000 cycles - gold plated brass contacts (code 0) : 60.000 cycles (0,4VA max.) MATERIALS GENERAL SPECIFICATIONS E Case : PES Travel : 2,20 mm (.086), except actuator N on SP model : 2,60 mm (.102) Actuator : polyamide, glass Operating temperature : -30C to +85C filled Recommended soldering : 300C 5 sec. max. Cover : stainless steel Contacts 0 : brass, gold plated 1 : silver 2 : silver, gold plated 5 : special contact, lower rating, minimum quantity : consult factory Terminal seal : epoxy E-8 www.apem.com APEM 04-Serie G-A 04-Serie G-A 21/11/12 18:25 Page9 G series Slide switches - telecom grade Overview G SERIES Actuators Number Electrical functions Terminals of poles C 3,50 mm (.137) S0 Solder lugs 6 ON - ON 3 Single pole H 5,10 mm (.200) P0 Straight PC 9 ON OFF ON 4 Double pole Standard W0 Right angle, horizontal L 6,40 mm (.251) WW Right angle, vertical B 7,65 mm (.301) Y0 Straight PC with short E 9,10 mm (.358) bracket N 9,50 mm (.374) Y4 Straight PC with tall bracket Types L, B and E for single pole models only. Special options 2 Contact and terminal Special options 1 materials 00 No epoxy seal 00 Standard model E 01 Epoxy sealed 0 Brass, gold plated 10 Switch without ground terminals 1 Silver plate 10 Extended terminals 2 Silver, gold plated 11 10,35 mm (.407) 5 Special contact, lower 11 Same as 10, with PC terminals epoxy seal rating 12 Same as 11, without ground plate ABOUT THIS SERIES On the following pages, you will find successively : - model structure of switches - options in the same order as in above chart Dimensions : first dimensions are in mm while inches are shown as bracketted numbers. NOTICE : please note that not all combinations of above numbers are available. Refer to the following pages for further information. Packaging unit : 100 pieces for SP solder lug (S0) and straight terminal (P0) models. 50 pieces for other models. APEM www.apem.com E-9