ACE1V4532-101-R Eaton

Technical Data 10986 Effective November 2019 ACE1V4532 Automotive grade common-mode chip inductor Applications Controller area network (CAN) Ethernet architectures Automotive signal line filter Advanced driver assistance systems (ADAS) Infotainment, safety cameras, sensors, xEV, Powertrain Engine control unit (ECU) Product features Electric power steering system (EPS) AEC-Q200 qualified Battery management systems (BMS) 1812 (4532 metric) package Impedance range from 700 ohms to 15000 ohms Environmental compliance and general Inductance range from 11 uH to 200 uH specifications Moisture sensitivity level (MSL): 1 Operating temperature range: -40 C to +125 C (ambient plus self-temperature rise) Solder reflow temperature: J-STD-020 (latest revision) compliant HALOGEN HF Pb FREEACE1V4532 Technical Data 10986 Effective November 2019 Automotive grade common-mode chip inductor Product specifications Common-mode Common-mode DCR () Insulation impedance Z () at inductance (H) at +25 Idc (mA) Rated voltage resistance Part number 10 MHz 100 kHz maximum maximum (Vdc) typical (M) minimum ACE1V4532-110-R 300 minimum 11 +50%/-30% 0.60 250 50 10 700 typical ACE1V4532-220-R 500 minimum 22 +50%/-30% 1.00 200 50 10 1000 typical ACE1V4532-510-R 1000 minimum 51 +50%/-30% 1.00 200 50 10 2000 typical ACE1V4532-101-R 2000 minimum 100 +50%/-30% 2.00 150 50 10 5000 typical ACE1V4532-201-R 10000 minimum 200 +50%/-30% 4.50 100 50 10 15000 typical 1. Part Number Definition: ACE1V4532-xxn-R ACE1V4532 = Product code and size xx= inductance value in uH, n= multiplication factor: 10 n (i.e. 110 = 11 * 10 0 = 11 uH) -R suffix = RoHS compliant Mechanical parameters, schematic, pad layout (mm) Recommended pad layout B A Epoxy C D Terminations Wires E E Equivalent circuit FF 1 4 2 3 No polarity Part Number A B C D E F ACE1V4532-xxn-R 4.50.2 3.2 0.2 2.8 0.2 0.2 0.1 1.2typ. 1.0typ. All soldering surfaces to be coplanar within 0.1 millimeters Tolerances are 0.1 millimeters unless stated otherwise Pad layout dimensions are reference only Traces or vias underneath the inductor is not recommended 2 www.eaton.com/electronics