Preliminary MPR Pressure Sensor X214676MPR Fully calibrated and temperature compensated Calibrated from 0 to 60 PSI Absolute 3%FSS Total Error Band after customer zero adjus) I2C Output 3.3 Vdc Operating voltage Low power consumption (<10 mW typ.), energy efficient REACH and RoHS compliant Compatible with liquid media Meets IPC/JEDEC J-STD020E Moisture Sensitivity Level 1 X214676MPR pressure sensors are designed to measure absolute pressures for air, non-corrosive gases and liquids and are specially calibrated to optimize performance over the specified pressure range. The internal components are protected by a fluorosilicone gel. ASIC calibrated 240hZ typical update rate Nominal Transfer Function Nominal Output 100 90 80 70 0 60 60 10 90 50 40 30 20 10 0 0 10 20 30 40 50 60 70 Pressure Low Calibration Pressure 0 PSI Output at Low Calibration Pressure 10 % 2 High Calibration Pressure 60 PSI Output at High Calibration Pressure 90 % 2 Absolute Maximum Ratings Supply voltage -0.3 V to 3.6 V Minimum Operating voltage 1.8 V Voltage on output pin -0.3 V to V +0.3 V supply Lead soldering temperature 250C, 15 seconds max. Maximum reflow cycles 2 Storage temperature range -40C to 85C Overpressure 250 PSI Burst pressure 275 PSI PRELIMINARY Datasheet creation date: 12/3/2019 Created by MPR Configurator 2.7 Preliminary Page 1 of 2 Specifications Subject to Change OutputPreliminary MPR Pressure Sensor Operating Specifications Compensated Supply voltage 3.3 V Supply current in standby mode 0.0005 mA Typical Supply current in active mode 1.7 mA Typical Compensated temperature range 0C to 50C Operating temperature range -40C to 85C Total Error Band after Customer Auto-Zero 3 %FSS Combined error from calibration, accuracy and temperature effects after Customer zero adjust. Accuracy 0.25% FSS Best Fit Straight Line Includes non-linearity, hysteresis and non-repeatability at 25C. Response Time 4.166 ms Typical Digital Interface Standard I2C Output (Address0x28) Resolution 14 Bit Environmental Specifications Humidity all extrnal surfaces 0% to 95% RH, non-condensing internal surfaces 0% to 100% RH, condensing Vibration MIL-STD-202G, Method 204D, Condition B (10 g, 10 Hz to 2 kHz) Shock MIL-STD-202G, Method 213B, Condition C (50 g, 6 ms duration) ESD 4kV, Human Body Model For for more information, including dimensions and pinout information, please refer to the MPR platform datasheet. Except as shown on this document, specifications for MPRSL0030PA00002A Apply PRELIMINARY Specifications subject to change Datasheet creation date: 12/3/2019 Created by MPR Configurator 2.7 Preliminary Page 2 of 2 Specifications Subject to Change