SF2237C High Performance SAW Filter 5 x 5 mm Surface-mount Package Complies with Directive 2011/65/EU (RoHS) Pb 515.0 MHz SAW Filter Absolute Maximum Ratings Rating Value Units Maximum Incident Power in Passband +10 dBm Maximum DC Voltage Between any Two Active Terminals 3 VDC Operable Temperature Range -45 to +125 C -40 to +85 C Specification Temperature Range Storage Temperature Range in Tape and Reel -40 to +85 C Suitable for Lead-free Soldering - Maximum Soldering Profile 260 C for 30 s SM5050-8 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units Nominal Center Frequency f 515.0 MHz C Insertion Loss 510 - 520 MHz 2.7 3.0 dB 1 dB Bandwidth BW 18 34 MHz 1 Amplitude Ripple, f 11.5 MHz dB 0.6 1.5 C P-P Rejection referenced to IL at Peak : 400 to 430 MHz 35 50 430 to 470 MHz 32 40 dB 550 to 600 MHz 20 30 600 to 740 MHz 35 40 Frequency Temperature Drift -93 ppm/C Case Style 5 x 5 mm Nominal Footprint Lid Symbolization, Y=year, WW=week, S=shift, Dot=pin 1 indicator 971, YWWS Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel Reel Size 13 Inch 3000 Pieces/Reel Electrical Connections Connection Terminals Input 1 Output 5 Case Ground All others CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating tem- 4.LRI or after the part number indicateslow rate initial productio perature range with filter soldered to the specified demonstration board andEN or indicatesengineering prototypes with impedance matching to 50 and measured with 50 network ana- 5. The design, manufacturing process, and specifications of this filter are lyzer. subject to change. 2. Unless noted otherwise, all frequency specifications are referenced to the 6. Either Port 1 or Port 2 may be used for either input or output in the design. nominal center frequency, fc. However, impedances and impedance matching may vary between Port 1 3. Rejection is measured as attenuation below the minimum IL point in the and Port 2, so that the filter must always be installed in one direction per passband. Rejection in final user application is dependent on PCB layout the circuit design. and external impedance matching design. See Application Note No. 42 7. US and international patents may apply. for details. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. Copyright Murata Manufacturing Co., Ltd. All rights reserved. Apr 2016 SF2237C (R) 1/3/18 Page 1 of 5 www.murata.comFilter Amplitude and Group Delay Response Plots S21 Response: (span 350 MHz) Group Delay Response: (span 50 MHz) Copyright Murata Manufacturing Co., Ltd. All rights reserved. Apr 2016 www.murata.com SF2237C (R) 1/3/18 Page 2 of 5