SF2240E Low-loss RF SAW Filter Surface Mount 3.0 x 3.0 x 1.3 mm Package Complies with Directive 2002/95/EC (RoHS) Pb 2595 MHz SAW Filter Absolute Maximum Ratings Rating Value Units Input Power Level 10 dBm DC Voltage on any Non-ground Terminal 3 V Operating Temperature Range -30 to +85 C Storage Temperature Range in Tape and Reel -40 to +95 C C Solder Reflow Temperature, 10 seconds, 5 cycles maximum 260 SM3030-6 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units F Center Frequency 2595 MHz C Maximum Insertion Loss, 2575 to 2615 MHz IL 3.2 4.0 dB dB Amplitude Ripple, 2575 to 2615 MHz 1.6 2.2 P-P VSWR, 2575 to 2615 MHz 1.4:1 2.3:1 Attenuation Referenced to 0 dB: DC to 1100 MHz 37 42 1100 to 2100 MHz 31 42 2100 to 2465 MHz 40 43 2465 to 2530 MHz 10 20 dB 2665 to 2675 MHz 10 30 2675 to 2695 MHz 35 48 2695 to 4000 MHz 30 36 Frequency Temperatue Coefficient -36 ppm/K Source Impedance Z 50 S Load Impedance Z 50 L Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator 974, YWWS Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel Reel Size 13 Inch 3000 Pieces/Reel CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance matching to 50 and measured with 50 network analyzer. 2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc. 3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details. 4.LRI or after the part number indicateslow rate initial productio andEN or indicatesengineering prototypes 5. The design, manufacturing process, and specifications of this filter are subject to change. 6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design. 7. US and international patents may apply. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. Copyright Murata Manufacturing Co., Ltd. All Rights Reserved 2015 SF2240E (R) 8/19/16 Page 1 of 6 www.murata.comFilter Test Circuit Connection Terminals Input 2 Output 5 Ground All Others Filter Broadband Response, 10 to 4000 MHz Copyright Murata Manufacturing Co., Ltd. All Rights Reserved 2015 www.murata.com SF2240E (R) 8/19/16 Page 2 of 6