SF2307D Low-loss SAW Filter 3.8 x 3.8 x 1.4 mm Surface-mount Package Pb 353.5 MHz Complies with Directive 2002/95/EC (RoHS) SAW Filter Absolute Maximum Ratings Rating Value Units Maximum Incident Power in Passband 15 dBm Maximum DC Voltage on any Non-ground Terminal 3 VDC Storage Temperature Range in Tape and Reel -40 to +85 C Operating Temperature Range -30 to +80 C Suitable for Lead-free Soldering - Maximum Soldering Profile 260 C for 30 s SM3838-6 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units Center Frequency f 353.5 MHz C Insertion Loss IL 1 1.5 3.5 dB Bandwidth BW 7 MHz Amplitude Ripple, f 3.5 MHz 3.0 dB C P-P Rejection Referenced to IL: 0.3 to 345.0 MHz 30 50 360 to 362 MHz 1, 2, 3 623 dB 362 to 367 MHz 20 30 367 to 2000 MHz 25 45 VSWR, f 3.5 MHz 1.5:1 2.0:1 C Case Style SM3838-6 3.8 x 3.8 mm Nominal Footprint Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator A57, YWWS Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel Reel Size 13 Inch 3000 Pieces/Reel Electrical Connections Connection Terminals Input Port 2 Output Port 5 Ground All others CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating tem- andEN or indicatesengineering prototypes perature range with filter soldered to the specified demonstration board 5. The design, manufacturing process, and specifications of this filter are with impedance matching to 50 and measured with 50 network ana- subject to change. lyzer. 6. Either Port 1 or Port 2 may be used for either input or output in the design. 2. Unless noted otherwise, all frequency specifications are referenced to the However, impedances and impedance matching may vary between Port 1 nominal center frequency, fc. and Port 2, so that the filter must always be installed in one direction per 3. Rejection is measured as attenuation below the minimum IL point in the the circuit design. passband. Rejection in final user application is dependent on PCB layout 7. US and international patents may apply. and external impedance matching design. See Application Note No. 42 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered for details. trademarks of Murata Manufacturing Co., Ltd. 4.LRI or after the part number indicateslow rate initial productio Copyright Murata Manufacturing Co., Ltd. All rights reserved. SF2307D (R) 4/29/16 Page 1 of 4 www.murata.comFilter Response Plots Copyright Murata Manufacturing Co., Ltd. All rights reserved. www.murata.com SF2307D (R) 4/29/16 Page 2 of 4