SF2388E Surface Mount 3.0 x 3.0 mm Package Complies with Directive 2002/95/EC (RoHS) Pb For the GPS L5 Band 1176.45 MHz Meets AEC-Q200 Standards SAW Filter Absolute Maximum Ratings Rating Value Units Input Power Level 10 dBm DC Voltage 7.5 V Operating Temperature Range -40 to +85 C Storage Temperature Range in Tape and Reel -40 to +85 C Suitable for Lead-free Soldering - Maximum Soldering Profile 260C for 30 s SM3030-6 Electrical Characteristics Sym Notes Min Typ Max Min Typ Max Units Characteristic -40 to +85C -40 to +105C f Center Frequency 1176.45 1176.45 MHz C Insertion Loss, 1166.45 to 1186.45 MHz IL 3.3 4.1 3.3 4.3 dB Amplitude Ripple, 1166.45 to 1186.45 MHz 1.0 1.5 1.0 1.8 Attenuation, Referenced from 0dB: 1121.45 MHz 30 42 30 42 dB 1231.45 MHz 30 45 30 45 Input/Output VSWR, 1166.45 to 1186.45 MHz 1.5 2.0 1.5 2.2 Source Impedance Z 50 50 S Load Impedance Z 50 50 L Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator 6V, YWWS Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel Reel Size 13 Inch 3000 Pieces/Reel Electrical Connections Connection Terminals 50 50 5 Input 2 2 SF2388E Output 5 Case Ground All others 1, 3, 4, 6 CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance matching to 50 and measured with 50 network analyzer. 2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc. 3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details. 4.LRI or after the part number indicateslow rate initial productio andEN or indicatesengineering prototypes 5. The design, manufacturing process, and specifications of this filter are subject to change. 6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design. 7. US and international patents may apply. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. Copyright Murata Manufacturing Co., Ltd. All Rights Reserved June 2015 SF2388E 5/22/18 Page 1 of 4 www.murata.comSF2388E Frequency Characteristics Copyright Murata Manufacturing Co., Ltd. All Rights Reserved June 2015 SF2388E 5/22/18 Page 2 of 4 www.murata.com