74HC563N,652

INTEGRATED CIRCUITS DATA SHEET For a complete data sheet, please also download: The IC06 74HC/HCT/HCU/HCMOS Logic Family Specifications The IC06 74HC/HCT/HCU/HCMOS Logic Package Information The IC06 74HC/HCT/HCU/HCMOS Logic Package Outlines 74HC/HCT563 Octal D-type transparent latch 3-state inverting December 1990 Product specication File under Integrated Circuits, IC06Philips Semiconductors Product specication Octal D-type transparent latch 3-state 74HC/HCT563 inverting FEATURES TTL (LSTTL). They are specified in common to all latches. compliance with JEDEC standard no. When LE is HIGH, data at the D n 3-state inverting outputs for bus 7A. inputs enter the latches. In this oriented applications condition the latches are transparent, The 74HC/HCT563 are octal D-type Inputs and outputs on opposite i.e. a latch output will change state transparent latches featuring sides of package allowing easy each time its corresponding D-input separate D-type inputs for each latch interface with microprocessor changes. and inverting 3-state outputs for bus Common 3-state output enable oriented applications. When LE is LOW the latches store the input A latch enable (LE) input and an information that was present at the Output capability: bus driver output enable (OE) input are common D-inputs a set-up time preceding the to all latches. HIGH-to-LOW transition of LE. I category: MSI CC When OE is LOW, the contents of the The 563 is functionally identical to 8 latches are available at the outputs. the 573, but has inverted outputs. GENERAL DESCRIPTION When OE is HIGH, the outputs go to The 563 consists of eight D-type the high impedance OFF-state. The 74HC/HCT563 are high-speed transparent latches with 3-state Operation of the OE input does not Si-gate CMOS devices and are pin inverting outputs. The LE and OE are affect the state of the latches. compatible with low power Schottky QUICK REFERENCE DATA GND = 0 V T =25 C t =t = 6 ns amb r f TYPICAL SYMBOL PARAMETER CONDITIONS UNIT HC HCT t t propagation delay D , LE to Q C = 15 pF V =5 V 14 16 ns PHL/ PLH n n L CC C input capacitance 3.5 3.5 pF I C power dissipation capacitance per latch notes 1 and 2 19 19 pF PD Notes 1. C is used to determine the dynamic power dissipation (P in W): PD D 2 2 P =C V f + (C V f ) where: D PD CC i L CC o f = input frequency in MHz i f = output frequency in MHz o 2 (C V f ) = sum of outputs L CC o C = output load capacitance in pF L V = supply voltage in V CC 2. For HC the condition is V = GND to V I CC for HCT the condition is V = GND to V - 1.5 V I CC ORDERING INFORMATION See 74HC/HCT/HCU/HCMOS Logic Package Information. December 1990 2