Document Number MKE02P64M20SF0 NXP Semiconductors Rev. 7, 12/2019 Data Sheet: Technical Data MKE02P64M20SF0 KE02 Sub-Family Data Sheet Supports the following: MKE02Z16VLC2(R), MKE02Z32VLC2(R), MKE02Z64VLC2(R), MKE02Z16VLD2(R), MKE02Z32VLD2(R), MKE02Z64VLD2(R), MKE02Z32VLH2(R), MKE02Z64VLH2(R), MKE02Z32VQH2(R), and MKE02Z64VQH2(R) Key features System peripherals Power management module (PMC) with three power Operating characteristics modes: Run, Wait, Stop Voltage range: 2.7 to 5.5 V Low-voltage detection (LVD) with reset or interrupt, Flash write voltage range: 2.7 to 5.5 V selectable trip points Temperature range (ambient): -40 to 105C Watchdog with independent clock source (WDOG) Performance Programmable cyclic redundancy check module Up to 20 MHz Arm Cortex-M0+ core (CRC) Single cycle 32-bit x 32-bit multiplier Serial wire debug interface (SWD) Single cycle I/O access port Bit manipulation engine (BME) Memories and memory interfaces Security and integrity modules Up to 64 KB flash 64-bit unique identification (ID) number per chip Up to 256 B EEPROM Human-machine interface Up to 4 KB RAM Up to 57 general-purpose input/output (GPIO) Clocks Two up to 8-bit keyboard interrupt modules (KBI) Oscillator (OSC) - supports 32.768 kHz crystal or 4 External interrupt (IRQ) MHz to 20 MHz crystal or ceramic resonator choice Analog modules of low power or high gain oscillators One up to 16-channel 12-bit SAR ADC, operation in Internal clock source (ICS) - internal FLL with Stop mode, optional hardware trigger (ADC) internal or external reference, 31.25 kHz pre- Two analog comparators containing a 6-bit DAC trimmed internal reference for 16 MHz system clock and programmable reference input (ACMP) (able to be trimmed for up to 20 MHz system clock) Internal 1 kHz low-power oscillator (LPO) Timers One 6-channel FlexTimer/PWM (FTM) Two 2-channel FlexTimer/PWM (FTM) One 2-channel periodic interrupt timer (PIT) One real-time clock (RTC) NXP reserves the right to change the production detail specifications as may be required to permit improvements in the design of its products. Communication interfaces Two SPI modules (SPI) Up to three UART modules (UART) One I2C module (I2C) Package options 64-pin QFP/LQFP 44-pin LQFP 32-pin LQFP KE02 Sub-Family Data Sheet, Rev. 7, 12/2019 2 NXP Semiconductors