PEL00583 Pro Elec

Model No. PEL00583 NON MAINTAINED LED EMERGENCY PANEL MOUNT MINI SPOTLIGHT 1Please read these instructions carefully before starting installation and retain for future reference. The centre page test record can be removed and kept with the building fire safety records. IMPORTANT SAFETY INFORMATION RISK OF ELECTRICAL SHOCK. ALWAYS ISOLATE THE POWER AT THE MAINS BEFORE INSTALLING OR MAINTAINING THIS EMERGENCY LIGHT. This product must be installed by a competent person in accordance with the Building Regulations and the current edition of the IET Wiring Regulations (BS7671). This product is suitable for mounting on normally flammable surfaces such as wood, plasterboard or masonry. Emergency light fittings should have their own separate mains circuit, protected with an appropriate MCB or fuse. They should not share their supply with other lighting or electrical equipment. This product is suitable for connection to a 220-240V~ 50Hz. This product must be earthed. This product is for indoor use only and suitable for ceiling mounting. This product will only illuminate in the event of a mains failure (non-maintained). Ensure that after installation the equipment and accessories remain accessible for regular maintenance and testing. INSTALLATION NOTE: Before drilling any holes, check that there are no hidden obstructions behind the mounting surface such as pipes or cables. 1. Cut a 30mm diameter hole in the ceiling for the light fitting. 2. Feed the mains supply wiring down through the hole just cut. 3. Unscrew and remove the cover over the mains input connectors on the emergency pack. 4. Make connection to the mains supply using the terminal block on the emergency pack. Ensure that the correct polarities are observed i.e.: Brown Live terminal L Blue Neutral terminal N. Green/Yellow Earth terminal E 5. Refit the cover over the terminals feeding the cable out through the exit hole. 6. Write the current date on the battery pack in the space provided. 7. Connect the battery pack to the matching white in-line connector on the wires to the emergency pack. 8. Connect the lamp to the small black in-line connector to the emergency pack. 9. Insert the emergency pack and battery through the hole into the ceiling space and insert the lamp into the hole so it fits flush and is secure. 10. Turn on the power supply. The LED should light green to indicate that the battery is charging. 11. Perform the electrical tests specified in the Wiring Regulations (BS7671). 2