TGC4407-SM Ka - Band Upconverter Product Description The QORVO TGC4407-SM is a Ka-Band sub-harmonic upconverter with integrated LO buffer amplifier. The TGC4407-SM operates from an RF of 21.5 to 32.5 GHz and is designed using QORVOs pHEMT production process. The TGC4407-SM typically provides 13 dBm of input TOI at 10 dBm input power per tone and a conversion gain of -9 dB. The TGC4407-SM is available in a low-cost, surface mount 16 lead 3x3mm QFN package and is ideally suited for Point- to-Point Radio, and Ka-Band VSAT Ground Terminal. QFN 3x3 mm 16L Lead-free and RoHS compliant. Product Features RF Frequency Range: 21.5 32.5 GHz Applications Wideband IF Frequency: DC 7.0 GHz Sub-Harmonic Pumped LO Frequency: 11 16 GHz VSAT LO Input Power: 0 to 7.5 dBm Point-to-Point Radio Conversion Gain: -9 dB Test Equipment & Sensors Bias: Vd = 5 V, Id = 65 mA, Typical Package Dimensions: 3.0 x 3.0 x 0.85 mm Function Block Diagram Ordering Information Part No. Description TGC4407-SM Ka-Band Upconverter TGC4407-SMEVB TGC4407-SM EVB Standard T/R size = 500 pieces on a 7 reel. Data Sheet Rev C. March 9, 2020 Subject to change without notice 1 of 16 www.qorvo.com TGC4407-SM Ka - Band Upconverter Recommended Operating Conditions Absolute Maximum Ratings Parameter Rating Parameter Min Typ Max Units Drain Voltage, Vd +7 V Operating Temp. Range -40 +25 +85 C Drain Current, Id 175 mA Vd 4 5 6 V Power Dissipation, Pdiss 1.2 W Id 65 mA Id drive +10 dBm RF Input Power, CW, 50, T = 25 C 76 mA (Under RF Drive) Channel Temperature, Tch 200 C Electrical specifications are measured at specified test conditions. Mounting Temperature (30 seconds) 260 C Specifications are not guaranteed over all recommended operating Storage Temperature -40 to 150 C conditions. These are stress ratings only, functional operation of the device at these conditions is not implied. Extended application of Absolute Maximum Rating conditions may reduce device reliability. Operation of this device outside the parameter ranges given above may cause permanent damage. Electrical Specifications Test conditions unless otherwise noted: 25C, Vd = 5 V, Id = 65 mA Typical. IF = 500 MHz, LO = 0 dBm. LSB = 2 x LO IF and USB = 2 x LO + IF. Parameter Conditions Min Typ Max Units RF Frequency Range 21.5 31.5 GHz LO Frequency Range 11 16 GHz IF Frequency Range DC 7 GHz Conversion Gain -9 dB Noise Figure 9 dB 2LO-to-RF Isolation, OIP3 35 dB Input IP3 13 dBm Input 1dB Compression (P1dB) 4 dBm Supply Current 65 mA Data Sheet Rev C. March 9, 2020 Subject to change without notice 2 of 16 www.qorvo.com