EVK5P35023PROG

VersaClock 3S - 5P3502x Family Programmer Board USER GUIDE Introduction The VersaClock 3S - 5P3502x USB programmer board is designed to ease the way of configuring and programming the blank parts of 5P3502x family of devices. With the on-board USB interface, IDT Timing Commander GUI can communicate with the VersaClock 3S devices for configuration and measurement on the board. With additional socket board, configuration can be programmed to blank parts of 5P3502x. The family of VersaClock 3S devices is available on the following part numbers: 5P35023 and 5P35021. Board Overview The USB programmer board (Figure 1) is ready with all necessary components and connections. It is available to test the functionality of the configuration and device can be programmed with the additional socket board as shown in Figure 2. Figure 1. Programmer Board Overview Table 1: Programmer Board Labels and Functions Serial Label Description 0 Single-ended Outputs These are test points for Single-ended Outputs SE1, SE2, SE3 and Reference with GND points in between. 1 DIP Switch This is used to configure the IC in different modes. 2 Clock Inputs A differential clock can be connected as the source for the device or a single-ended input connected on CLKINB pin. May, 27 2016 1 2016 Integrated Device Technology, Inc. VERSACLOCK 3S - 5P3502x Family Programmer Board Serial Label Description 3 Socket connector This is used to mount a 24 or 20 PIN socket board on the top of USB board for programming. 4 25MHz Crystal Crystal with 8pF load (part number: 603-25-150) is populated. 5 Differential Outputs This is the differential pair (Out of phase): DIFF-T2 and DIFF-C2. 6 Chip This device (5P35023) is populated. 7 Socket This is used to mount a 24 or 20 PIN socket board on the top of USB board for programming. 8 Differential Output This is another set of differential pair (Out of phase): DIFF-T1 and DIFF-C1. Table 2: Programming Steps Step No. Steps Comments 1 Plug the board into the USB port USB provides power to the board and establishes a communication channel between GUI and the device 2 Start Timing Commander Software Launch the Timing Commander GUI software. Load the personality file. Timing Commander Software Timing Commander Software for VersaClock 3S - 5P35023 User Guide 3 New settings file Using the Timing Commander GUI, start a new settings file, or open a pre-optimized file. 4 Connect to the board Upon finalizing the configuration, click on the chip symbol on the top right corner of the GUI window. 5 Once connected new options will be available on a green background indicating that the USB board has successfully connected with the board. 6 All intended outputs should be available for Once the outputs have been validated and measurement finalized, disconnect the USB board and install the socket board. Establish GUI connection to the DUT, write all, then proceed to the OTP burn. See OTP Programming section. May, 27 2016 2