LINCOLN Remote Control System AM Remote Control 100 metres Range 1 or 4 channel variants High Security 1 Million possible Addresses 4 x Relay Outputs Latch/Momentary Option Easy Learn CR2016 battery Applications Description The LINCOLN is a versatile general purpose remote control, which can be used for controlling many different applications Supplied ready to go, the receiver contains changeover contact relays that are easy to connect via screw terminals. Power to the receiver is 12Vdc and the output(s) can switch up to 10A at 230Vac. FFrreqeq RangRange*e*** PParartt Nu Numbmberer DescDescrriptiptionion ((MMHzHz)) ((MMetresetres)) LINCOLN-4S1 1 channel System 433 100 LINCOLN-4S4 4 channel System 433 100 LINCOLN-4T1 1 channel Transmitter Keyfob 433 100 LINCOLN-4T4 4 channel Transmitter Keyfob 433 100 * Range stated is optimal, in some conditions this may be dramatically reduced. DS-LINCOLN-1 NC COM NO NC COM NO LINCOLN Remote Control System Connecting the Receiver Unit Each Channel output relay provides an isolated changeover Contact. Outputs 2 to 4 Connections are Common (COM) and Normally Open (NO) which close together when activated. Output 1 has an addi- tional Normally Closed (NC) changeover contact. Relay Connections when Relay Connections when Transmitter NOT Operating Transmitter OPERATING The action of the relay outputs is set by the Option link setting Jumper. A link is made / removed by the small shorting link cap placed over the pin header. LINCOLN-4S1 Receiver Circuit board LINCOLN-4S1 Receiver Circuit board Learn Switch LINK 1 1 Settings 2 Place A - NO 2 Header 3 on Here B - COM 3 LED C - NC LINKS Learn Switch LED Link Postion Controls Outputs FFiittettedd 1 1--2=2= MoMommenentartaryy FFiittettedd 2 2--3=3= LaLatctchihingng Not FiNot Fitttedted == FFlliipFpFllopop Power IN Momentary : The relay is activated for as long as transmitter button pressed. Latching : The relay toggles between On / Off each button press. FlipFlop : Relays 1 & 2 and 3 & 4 operate in pairs. When button 1 is pressed relay 1 switches on, Relay 2 Switches off When button 2 is pressed relay 2 switches on, Relay 1 Switches off Relay 3 & 4 operate in the same manor to Transmitter buttons 3 & 4. Learning a New Transmitter Keyfob Briefly Press the Learn Switch on the receiver PCB, the receiver LED will illuminate. Press any transmitter button once, the receiver LED will flash 3 times. This transmitter will operate the system. Erasing Existing Transmitters Press and hold the receiver Learn Switch, the receiver LED illuminates. When the LED extinguishes (5-10 seconds) the Receiver is erased. NOTE: You can not erase individual Tx encoders NOTE: maximum of 45 button pairings per receiver DS-LINCOLN-1 NO COM NC