STEVAL-IPT005V1 STMicroelectronics

STEVAL-IPT005V1 Smart card interface evaluation board based on the ST8034P Data brief Description The STEVAL-IPT005V1 product evaluation board is designed both for standalone operation or to be controlled by the microcontroller. The board is fully configurable, provides access to all signals including supply voltage through labeled test points, and uses a standard connector for simple communication interfacing with the microcontroller block. The labeled test points on the board are in the same order as the signals in the flat interface cable. The board provides easy and flexible card supply voltage (V ) selection, either through the CC onboard configuration switch (driving the tri-state Features V selection input pin VCC SEL) or through the CC microcontroller. Smartcard connector for testing with a smartcard The STEVAL-IPT005V1 product evaluation board addresses market segments including: POS, set- Labeled testpoints provide accessibility to all top boxes, pay TV, identification, banking and the signals tachographs. Board design allows standalone operation for basic tests Interface to an MCU block and simple board configurability allow even full functioning in applications (i.e. set-top box) Onboard 10 MHz crystal clock oscillator can be used to provide card clock in standalone operation Card clock source selection switch allows selection between the onboard crystal oscillator as card clock source, or an external clock source provided by the microcontroller block through the MCU interface together with the data signals Provides easy, flexible card supply voltage selection either by onboard configuration switches or remotely by the microcontroller RoHS compliant April 2014 DocID025478 Rev 2 1/4 For further information contact your local STMicroelectronics sales office. www.st.comSchematic diagram STEVAL-IPT005V1 1 Schematic diagram Figure 1. STEVAL-IPT005V1 circuit schematic 2/4 DocID025478 Rev 2