STLVDS050BDR STMicroelectronics

STLVDS050 High speed differential line drivers and receivers Feature summary Meets or exceed the requirements of ansi eia/tia-644-1995 standard Signaling rates up to 400Mbit/s Bus terminal ESD exceeds 6kV Operates from a single 3.3V supply Low-voltage differential signaling with typical output voltage of 350mV and a 100 load TSSOP Propagation delay times: Driver: 2ns (typ) Receiver: 3ns (typ) Power dissipation at 200MHz: Driver: 25mW (typ) Receiver: 60mW (typ) LVTTL input levels are 5V tolerant The intended application of this device an Receiver has open-circuit fail-safe signaling technique is for point-to-point baseband data transmission over controlled impedance media of approximately 100 characteristic Description impedance. The STLVDS050 is differential line drivers and The transmission media may be printed-circuit receivers that use low-voltage differential board traces, backplanes, or cables. (Note: The signaling (LVDS) to achieve signaling rate as high ultimate rate and distance of data transfer is as 400Mbps. dependent upon the attenuation characteristics of The EIA/TIA-644 standard compliant electrical the media, the noise coupling to the environment, interface provides a minimum differential output and other application specific characteristics). voltage magnitude of 247mV into a 100 load . and receipt of 100mV signals with up to 1V of ground potential difference between a transmitter and receiver. Order codes Temperature Part number Package Comments Range STLVDS050BTR -40 to 85 C TSSOP16 (Tape & Reel) 2500 parts per reel March 2006 Rev. 4 1/15 www.st.com 15 Obsolete Product(s) - Obsolete Product(s) STLVDS050 Contents 1 Pin configuration . 3 2 Maximum ratings 5 3 Electrical characteristics . 6 4 Typical performance characteristics 9 5 Package mechanical data 11 6 Revision history . 14 2/15 Obsolete Product(s) - Obsolete Product(s)