VN7140AJ, VN7140AS Datasheet High-side driver with MultiSense analog feedback for automotive applications Features V Max transient supply voltage 40 V CC V Operating voltage range 4 to 28 V CC R Typ. on-state resistance (per Ch) 140 m ON I Current limitation (typ) 12 A LIMH I Standby current (max) 0.5 A STBY AEC-Q100 qualified General Single channel smart high-side driver with MultiSense analog feedback Very low standby current Compatible with 3 V and 5 V CMOS outputs MultiSense diagnostic functions Multiplexed analog feedback of: load current with high precision proportional current mirror, V supply voltage and T device CC CHIP temperature Overload and short to ground (power limitation) indication Thermal shutdown indication OFF-state open-load detection Output short to V detection CC Product status link Sense enable/disable VN7140AJ Protections VN7140AS Undervoltage shutdown Overvoltage clamp Load current limitation Self limiting of fast thermal transients Configurable latch-off on overtemperature or power limitation with dedicated fault reset pin Loss of ground and loss of V CC Reverse battery with external components Electrostatic discharge protection Applications All types of automotive resistive, inductive and capacitive loads Specially intended for automotive signal lamps (up to R10W or LED Rear Combinations) Protected supply for ADAS systems: radars and sensors Description The devices are single channel high-side drivers manufactured using ST proprietary VIPower M0-7 technology and housed in PowerSSO-16 and SO-8 packages. The DS10830 - Rev 4 - April 2019 www.st.com For further information contact your local STMicroelectronics sales office.VN7140AJ, VN7140AS devices are designed to drive 12 V automotive grounded loads through a 3 V and 5 V CMOS-compatible interface, and to provide protection and diagnostics. The devices integrate advanced protective functions such as load current limitation, overload active management by power limitation and overtemperature shutdown with configurable latch-off. A FaultRST pin unlatches the output in case of fault or disables the latch-off functionality. A dedicated multifunction multiplexed analog output pin delivers sophisticated diagnostic functions including high precision proportional load current sense, supply voltage feedback and chip temperature sense, in addition to the detection of overload and short circuit to ground, short to V and OFF-state open-load. CC A sense enable pin allows OFF-state diagnosis to be disabled during the module low- power mode as well as external sense resistor sharing among similar devices. DS10830 - Rev 4 page 2/45