RoHS Compliance This component is compliant with RoHS directive. This component was always RoHS compliant from the first date of manufacture. SF2201E Low-loss SAW Filter Surface Mount 3.0 x 3.0 x 1.3 mm Package 916.45 MHz Absolute Maximum Ratings SAW Filter Rating Value Units Input Power Level +17 dBm DC Voltage on any Non-ground Terminal 5 V Operable Temperature Range -45 to +125 C Specification Temperature Range -30 to +85 C Storage Temperature Range in Tape and Reel -40 to +85 C C Maximum Soldering Profile, 5 cycles/10 seconds maximum 265 SM3030-6 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units Center Frequency F 916.45 MHz C Insertion Loss, 914.45 to 918.45 MHz IL 2.7 3.5 dB Amplitude Ripple, 914.45 to 918.45 MHz 0.3 1.0 dB P-P VSWR, 914.45 to 918.45 MHz 1.5:1 2.0:1 Attenuation Referenced to 0 dB DC to 600 MHz 50 57 600 to 840 MHz 40 51 869 to 894 MHz 35 46 dB 970 to 1500 MHz 40 47 1500 to 3000 MHz 25 32 Source Impedance Z 50 S Load Impedance Z 50 L Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator 931, YWWS Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel Reel Size 13 Inch 3000 Pieces/Reel Electrical Connections Connection Terminals Input 2 Output 5 Ground All Others CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance matching to 50 and measured with 50 network analyzer. 2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc. 3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details. 4.LRI or after the part number indicateslow rate initial productio andEN or indicatesengineering prototypes 5. The design, manufacturing process, and specifications of this filter are subject to change. 6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design. 7. US and international patents may apply. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. Copyright Murata Manufacturing Co., Ltd. All rights reserved. February 2015 SF2201E (R) 7/10/18 Page 1 of 6 www.murata.comFilter Passband Response Filter Test Circuit SF2201E 2010-2015 by Murata Electronics N.A., Inc. SF2201E (R) 7/10/18 Page 2 of 6 www.murata.com