SF2211E No Matching Network Required for 50 Operation Surface-mount 3.0 x 3.0 mm Package Complies with Directive 2002/95/EC (RoHS) Pb 1200 MHz SAW Filter Absolute Maximum Ratings Rating Value Units Input Power Level 10 dBm DC Voltage on any Non-ground Terminal 3V Operating Temperature Range -55 to +85 C Storage Temperature Range in Tape and Reel -40 to +85 C Component Storage Temperature Range -55 to +95 C Solder Reflow Temperature, 10 seconds, 5 cycles maximum 260 C SM3030-6 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units f Center Frequency 1200 MHz C Insertion Loss, 1180 to 1220 MHz IL 2.8 4.0 dB Attenuation, 0 dB Reference: 1080 MHz 35 60 1100 MHz 45 60 dB 1300 MHz 40 48 1320 MHz 35 52 Z 50 Source Impedance S Load Impedance Z 50 L Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator 945, YWWS Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel Reel Size 13 Inch 3000 Pieces/Reel Electrical Connections Connection Terminals Port 1 2 Port 2 5 Case Ground All others CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. Notes: 1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance matching to 50 and measured with 50 network analyzer. 2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc. 3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details. 4.LRI or after the part number indicateslow rate initial productio andEN or indicatesengineering prototypes 5. The design, manufacturing process, and specifications of this filter are subject to change. 6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design. 7. US and international patents may apply. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. Copyright Murata Manufacturing Co., Ltd. All Rights Reserved 2015 SF2211E (R) 8/19/16 Page 1 of 5 www.murata.comFilter Frequency Response Copyright Murata Manufacturing Co., Ltd. All Rights Reserved 2015 www.murata.com SF2211E (R) 8/19/16 Page 2 of 5