Preliminary RFM products are now Murata products. SF2214E Low-loss 815 MHz Filter Complies with Directive 2002/95/EC (RoHS) Pb 815.00 MHz Absolute Maximum Ratings SAW Filter Rating Value Units +10 Input Power Level dBm DC Voltage on any Non-ground Terminal 5 V Operating Temperature Range -30 to +80 C Storage Temperature Range in Tape and Reel -40 to +85 C C Maximum Soldering Profile, 5 cycles/10 seconds maximum 265 SM3030-6 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units Center Frequency f 815.00 MHz C Insertion Loss, 805 to 825 MHz IL 2.8 3.5 dB Peak-to-Peak Amplitude Ripple, 805 to 825 MHz 1.0 2.0 dB Input/Output VSWR, 805 to 825 MHz SWR 1.9:1 2.5:1 Attenuation, Referenced to 0 dB: 10 to 780 MHz 40 63 851 to 856 MHz 28 50 856 to 869 MHz 40 47 dB 869 to 896 MHz 45 52 896 to 941MHz 40 62 960 to 2200 MHz 40 46 2200 to 2600 MHz 30 35 Z Source Impedance 50 S Z Load Impedance 50 L Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator 950, YWWS Standard Reel Quantity Reel Size 7 inch 500 Pieces/Reel Reel Size 13 inch 3000 Pieces/Reel Electrical Connections Connection Terminals Input 2 Output 5 Case Ground All others CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance matching to 50 and measured with 50 network analyzer. 2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc. 3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details. 4.LRI or after the part number indicateslow rate initial productio andEN or indicatesengineering prototypes 5. The design, manufacturing process, and specifications of this filter are subject to change. 6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design. 7. US and international patents may apply. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. 2010-2015 by Murata Electronics N.A., Inc. SF2214E (R) 10/14/15 Page 1 of 5 www.murata.comFilter Passband Response Filter Broadband Response 2010-2015 by Murata Electronics N.A., Inc. www.murata.com SF2214E (R) 10/14/15 Page 2 of 5