Document Number K60P144M120SF3 NXP Semiconductors Rev. 7, 02/2018 Data Sheet: Technical Data K60P144M120SF3 K60 Sub-Family Supports the following: MK60FX512VLQ12, MK60FN1M0VLQ12, MK60FX512VMD12, MK60FN1M0VMD12 Key features Security and integrity modules Hardware CRC module to support fast cyclic Operating Characteristics redundancy checks Voltage range: 1.71 to 3.6 V Hardware random-number generator Flash write voltage range: 1.71 to 3.6 V Hardware encryption supporting DES, 3DES, AES, Temperature range (ambient): -40 to 105C MD5, SHA-1, and SHA-256 algorithms Performance 128-bit unique identification (ID) number per chip Up to 120 MHz Arm Cortex-M4 core with DSP Human-machine interface instructions delivering 1.25 Dhrystone MIPS per Low-power hardware touch sensor interface (TSI) MHz General-purpose input/output Memories and memory interfaces Analog modules Up to 1024 KB program flash memory on non- Four 16-bit SAR ADCs FlexMemory devices Programmable gain amplifier (PGA) (up to x64) Up to 512 KB program flash memory on integrated into each ADC FlexMemory devices Two 12-bit DACs Up to 512 KB FlexNVM on FlexMemory devices Four analog comparators (CMP) containing a 6-bit 16 KB FlexRAM on FlexMemory devices DAC and programmable reference input Up to 128 KB RAM Voltage reference Serial programming interface (EzPort) FlexBus external bus interface Timers NAND flash controller interface Programmable delay block Two 8-channel motor control/general purpose/PWM Clocks timers 3 to 32 MHz crystal oscillator Two 2-channel quadrature decoder/general purpose 32 kHz crystal oscillator timers Multi-purpose clock generator IEEE 1588 timers System peripherals Periodic interrupt timers Multiple low-power modes to provide power 16-bit low-power timer optimization based on application requirements Carrier modulator transmitter Memory protection unit with multi-master Real-time clock protection 32-channel DMA controller, supporting up to 128 request sources External watchdog monitor Software watchdog Low-leakage wakeup unit NXP reserves the right to change the production detail specifications as may be required to permit improvements in the design of its products. Communication interfaces Ethernet controller with MII and RMII interface to external PHY and hardware IEEE 1588 capability USB high-/full-/low-speed On-the-Go controller with ULPI interface USB full-/low-speed On-the-Go controller with on-chip transceiver USB Device Charger detect (USBDCD) Two Controller Area Network (CAN) modules Three SPI modules Two I2C modules Six UART modules Secure Digital Host Controller (SDHC) Two I2S modules K60 Sub-Family, Rev. 7, 02/2018 2 NXP Semiconductors