HDMI05-CL01F3 5-line IPAD, HDMI control line ESD protection Datasheet - production data Features Low line capacitance High efficiency in ESD protection Lead-free package Very thin package High reliability offered by monolithic integration High reduction of parasitic elements through Leed-free Flip-Chip package (8 bumps) integration and wafer level packaging Complies with the standards: IEC 61000-4-2 Level 4 15 kV (air discharge) Figure 1. Pin configuration (bump side) and 8 kV (contact discharge) schematic IEC 61000-4-2 Level 1 2 kV (air discharge) 2 kV (contact discharge) Application 9 Where ESD protection for HDMI control lines (CEC, HPD, SCL and SDA) is required: 6 *1 % Mobile phones and communication systems Portable multimedia players Camcorder, digital still cameras +3 *1 & Description % DQG & EXPSV PXVW EH FRQQHFWHG WRJHWKHU LQ WKH 3&% The HDMI05-CL01F3 chip is a low capacitance 9 &(& ESD protection for HDMI control pins. It also integrates a pull-up resistor for IC bus and a pull- 6&/ 6 down resistor for hot plug detect. % +3 & The ESD protection circuitry prevents damage to the protected device when subjected to ESD 5 5 5 surges up to 15 kV. *1 *1 TM: IPAD is a trademark of STMicroelectronics. HDMI, the & % & HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC. July 2015 DocID17458 Rev 3 1/8 This is information on a product in full production. www.st.com 538 &(& 6&/Characteristics HDMI05-CL01F3 1 Characteristics Table 1. Absolute maximum ratings (T = 25 C) amb Symbol Parameter Value Unit External pins (A1, A2, A3, B3 and C3): 15 ESD IEC 61000-4-2, level 4 - air discharge ESD IEC 61000-4-2, level 4 - contact discharge 8 V kV PP Internal pin (C1): ESD IEC 61000-4-2, level 1 - air discharge 2 ESD IEC 61000-4-2, level 1 - contact discharge 2 P Line resistance power dissipation at 70 C 60 mW d T Operating temperature range -30 to + 85 C op T Storage temperature range -55 to + 150 C stg Figure 2. Electrical characteristics - definitions I Symbol Parameter V = Breakdown voltage BR I = Leakage current V RM RM IR V = Stand-off voltage RM VBR VRM IRM V C = Line capacitance IRM line VRM VBR IR Table 2. Electrical characteristics (T = 25 C) amb Symbol Test condition Min. Typ. Max. Unit V I = 1 mA 14 V BR R I V = 3 V per line 50 200 nA RM RM R , R 1575 1750 1925 1 2 R 80 100 120 k 3 V = 0 V, V = 30 mV, F = 1 MHz line osc C 810 12 pF (measured under zero light conditions, B2 and C2 line bumps connect together) 2/8 DocID17458 Rev 3