TC75W59FU/FK TOSHIBA CMOS Linear Integrated Circuit Silicon Monolithic TC75W59FU, TC75W59FK Dual Comparator TC75W59 is a CMOS type general-purpose dual comparator capable of single power supply operation and using lower supply currents than the conventional bipolar comparators. Its open drain output forms wired OR with other open drain outputs. Features z Low supply current: IDD = 200A (typ.) z Single power supply operation z Wide common mode input voltage range: V to V 0.9V SS DD z Open drain output circuit z Low input bias current z Small package Weight SSOP8-P-0.65: 0.021g (typ.) SSOP8-P-0.50A: 0.01g (typ.) Marking (Top View) Pin Connection (Top View) Start of commercial production 1997-05 1 2014-03-01 TC75W59FU/FK Absolute Maximum Ratings (Ta = 25C) Characteristic Symbol Rating N Supply voltage V , V 3.5 or 7 V DD SS Differential input voltage DV 7 V IN Input voltage V V to V V IN SS DD Output current I 35 mA O 250 (TC75W59FU) Power dissipation P mW D 200 (TC75W59FK) Operating temperature T 40 to 85 C opr Storage temperature T 55 to 125 C stg Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (Handling Precautions/Derating Concept and Methods) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note: Since this product sometimes brings about latchcap, which is peculiar to CMOS devices, note the following points: Dont raise the voltage level of I/O pins beyond V , nor lower it below V . DD SS Consider the timing for power supply, too. Dont let any abnormal noise enter the device. 2 2014-03-01