ISO8200AQ Datasheet Galvanic isolated octal high side smart power solid state relay with SPI interface Features V operating range: 10.5 V to 45 V CC I operating range: 0.7 A (per channel) OUT R = 0.120 (per channel) DS( on) 20MHz SPI interface with daisy chaining 5 V and 3.3 V TTL/CMOS and MCU compatible I/Os Common output enable/disable pin Fast demagnetization of inductive loads (V = V - 50 V DEMAG(TYP) CC Reset function for IC outputs disable Very low supply current Undervoltage shutdown with auto restart and hysteresis Short-circuit protection Per-channel overtemperature protection Thermal independence of separate channels Case overtemperature protection Loss of Ground and Supply protections Overvoltage protection (V clamping) CC Common OVT fault open drain output Power GOOD open drain output High common mode transient immunity ESD protection Product status link Designed to meet IEC 61000-4-2, IEC 61000- 4-4, IEC 61000-4-5 and IEC ISO8200AQ 61000-4-8 UL1577 and UL508 certified Product summary Order code ISO8200AQ ISO8200AQTR Applications Package TFQFPN32 Programmable logic control Packing Tube Tape & Reel Industrial PC peripheral input/output Product label Numerical control machines Drivers for all type of loads (resistive, capacitive, inductive) DS12812 - Rev 7 - July 2021 www.st.com For further information contact your local STMicroelectronics sales office.ISO8200AQ Description 1 Description The ISO8200AQ is a galvanic isolated 8-channel driver featuring a very low supply current. It contains 2 independent galvanic isolated voltage domains (V and V for the Process and Control Logic stages, CC DD respectively). The IC is intended for driving any kind of load with one side connected to ground. The Control Logic Stage features an 8-bit Output Status Register (where the microcontroller sets the ON/OFF status of the output channels in the Process Stage) and an 8-bit Fault Register (where the OVT faults of each channel are stored). The two stages communicate through the galvanic isolation channel via an ST proprietary protocol. Active channel current limitation (OVL) combined with thermal shutdown (OVT), independent for each channel, protects the device against overload and overtemperature. Additional embedded functions include loss of ground protection, V and V UVLOs (with hysteresis), CC DD watchdog and V Power GOOD. CC An internal circuit provides an OR-wired not latched common (FAULT) indicator signaling the channel OVT. The (PGOOD) diagnostic pin is activated if V falls below the power good internal threshold. Both (FAULT) and CC (PGOOD) pins are open drain, active low, fault indication pins. DS12812 - Rev 7 page 2/42